Craftsman 152.219070 Instruction Manual page 13

TOOL AND CHUSEL HOLDER FASTENING MACHINE TO
SUPPORTING SURFACE
Make sure that the machine is disconnected from the
power source,
Figure 13
Figure 14
2,
3,
®
C
\
\
\,
insert the support bar (A) into the support bracket
(B), See Figure 13,
PUace the support bar through the hob (C) of the
tooUand chbeU hoUder,
Use tool and chisel holder to store all chisels and
chuck keys when not in use,
,__ J
if during operation there is any tendency for the mortiser
to tip over, slide, or walk on the supporting surface, the
base must be secured to the supporting surface with
fasteners (not supplied), through the two hobs (A)
located in the mortiser base,
13