Advertisement
GEAppliances.com
D
Options
The light above the selected pad will be ON to indicate which OPTION has been selected.
HOT START/
For use with heavily soiled and/or dried-on, baked-on soils. This option NUST be
STEAM
selected PRIORto starting the cycle. This option will improve both wash and dry
(on some
performance. This option adds 20 minutes to the cycle time.
models)
NOTE:Cannot be selected with RINSEONLY cycle.
HEATEDDRY
Shuts off the drying heat option. Dishes air dry naturally and energy is saved.
Light OFF
For faster air dry you can prop the door open after the CLEAN light illuminates.
HEATEDDRY
Turns the heater on for fast drying. This will extend the total run time by 38 minutes.
Light ON
NOTE: Cannot be selected with RINSEONLY cycle.
LOCK
(on some
models)
You can lock the controls to prevent any selections from being made. Or you can lock
the controls after you have started a cycle.
Children cannot accidentally start dishwasher by touching pads with this option
selected.
To LOCK the dishwashercontrol,touch and holdthe HEATED DRY pad for 3 seconds. T helight below
the HEATED DRY pad willturn on.ToUNLOCK the dishwashercontrol, touch and holdthe HEATED
DRYpadfor 3 seconds. T heLOCKlightwillturn off.
HOT WASH/
ADDED HEAT
When selected, the cycle will run longer with the heating
element
on to improve
both
wash and dry performance.
For use with heavily soiled and/or dried-on
soils. This
option HUST be selected PRIOR to starting
the cycle. NOTE: Cannot be selected with
RINSE ONLY cycle.
DELAY HOURS
You can delay the start of a wash cycle for 2, 4 or 8 hours (delay time options may vary
by model). Touch the DELAYHOURSpad to choose the number of hours you want to
delay the start of the cycle; then touch START/RESET one time. The dishwasher will
count down and start automatically at the correct time. Touching START/RESET e
second time will cancel the DELAYSTARTselection.
RESET
To change a cycle after washing starts, touch the START/RESET pad to cancel the
cycle. For some models, the LED's indicating selected cycle and options will flash while
the water is pumped out. This takes approximately !05 seconds. When the lights stops
flashing, the dishwasher can be reprogrammed and restarted. Buttons will not respond
during pump out.
For other models, the LED's indicating the selected cycle and options will flash and the
drain pump will pump water out of the dishwasher for !05 seconds and then turn off.
Buttons will respond during pump out. If any button is pressed during the pump out,
the LED's will stop flashing and indicate new cycle or options selected. If the
START/RESET button is pressed while the dishwasher is in pump out, the dishwasher
will start a new wash cycle.
_
Start
Close and latch the dishwasher door and select the cycle and desired enhancements.
Touch the START/RESET pad once to begin the cycle. Water begins to fill the
dishwasher, and approximately 60 seconds later the wash action begins.
NOTE:The dishwasher remembers your last cycle so you don't have to reprogram each
time. When the dishwasher door is fully closed, the control panel lights will display the
last settings you selected.
If you don't want to change any of the settings, simply touch the START/RESET pad
once to begin the cycle.
If the door is closed, the indicator lights will turn off if the START/RESET pad is not
pressed within two minutes. To activate the display, open and close the door or touch
any pad.
Also, if a power failure occurs, NORMAL WASH and HEATEDDRY will automatically be
programmed.
9
Advertisement
