Craftsman 315.114840 Operator's Manual page 9

KNOW YOUR HAMMER DR(LL
See Figure 1.
Before attempting to use this product, familiarize yourself
with a(I operat(ng Features and Safety Rules,
KEYLESS CHUCK
Your drill-driver has a keyless chuck that allows you to
hand tighten or release dri(( bit in the chuck jaws,
SW(TCH
Your hammer dri(I has a conveniently located trigger
switch,
TWO-SPEED GEAR TRAIN
Your drill-driver has a two speed gear train designed for
drilling or driving at HI or LO speeds, A slide switch is
located on top of your dri(( to select either HI or LO speed,
This hammer drill allows you to reverse the bit rotation, You
can control the direction with the direction of rotation selec-
tor located above the switch,
SW(TCH LOCK
The switch trigger can be locked in the OFF position, This
feature helps reduce the possibility of accidenta( starting
when not in use,
ADJUSTABLE TORQUE CLUTCH
The hammer drill is equipped with an adjustable torque
clutch for driving different types of screws into different
materials,
DEPTH GAUGE ROD
A depth gauge rod is installed on the auxiliary handle
assembly to assist you in controlling the depth of drilled
holes,
AUXIMARY HANDLE ASSEMBLY
An auxiliary handle is installed on the hammer drill, For
ease of operation, you may use the handle with either the
left hand or the right hand,
LEVEL DR(LMNG
Two levels are recessed in the motor housing of the ham-
met dri(!, One is located on top, while the other is located
on the end, They can be used to keep dri(( bits level during
both horizontal and vertical drilling operations,
BiT STORAGE
When not in use, you can place the bits provided with your
hammer dri(( in the storage area located on the top of the
drill,
ERGONOM(C DESIGN
The design of the hammer drill provides for easy handling,
It is designed for comfort and ease of grasp when operat-
ing in different positions and at different angles,
CHARGER
Your charger has a "key hole" feature for convenient, space
saving storage, Screws should be installed so that center
distances are 4-1/2 inches apart,