Monogram ZISB360DRF Owner's Manual page 21

re and (;leaning
Built-In H_qrigeralors
Using
the Masto
Light switch
This teature turns off tile lights in tile fl'esh
tood and freezer compartn_ents.
The switch is located behind the grille panel
at the top of the refiigerator, i,ifl up the panel
to access the switch.
The switch is located
behindthe grille panel.
Type 1 bulb
replacement
NOTE: Before replacing tile bulbs, review
tile light bulb infiwmation and _4_M_NING.
Replacing Type 1 bulbs located in lamps
behind the top pma in the fresh food
compaxtment and the bottom freezer basket
in the freezer compartment:
1. Set tile Master I,ight switch to tile OFF
position (see IAinq" the Master Lig'hl s_vilck)
and allow tile lamps to cool.
2. To access tile lamps in tile fresh food
compartment, remove tile Hmniditv Control
pan. See Drawer and Pan Ra,,noval section.
Raise the lid of the pan up to expose the
light cover.
To access the lamps in the fl'eezer
coi//partlllent_ relllOVe tile bottolll ti'eezer
basket. See Freezzr Baskels section.
3. On tile back wall there is a crowed light
shield. Grasp each end of tile light shield.
Pull tile shield toward wm and tile tabs
on the shield will release fl'om the slots in
the housing.
4. Remove tile glass above tile bulbs by pulling
it straight out.
NOTE: Always follow bulb inanufilcturer's
directions tot handling and replacing bulbs.
5. Remove tile bulb by holding tile base and
pulling straight up. Replace with a new bulb.
6. Replace the glass by sliding it into place.
Then replace the light shield by resting the
top lip of the shield on top of the light
housing. Then press the sides until the tabs
pop into the slots in the housing.
-. ............... °_°
WARNING
- Tile light shield must
be replaced or tile heat from tile bulb could
damaoeo the refrigerator,
AVERTISSEMENT :
Vous devez remettre en place l'_cran _'llmni_re
pour ne pas endollllllager votre i'efl'igei'atetlr
avec la chalem" produite par l'ampoule.
7. Reset the Master i,ight switch to the ON
position.
21