GE QuicksetcIII Owner's Manual page 33

GEAppliances.com
:::Probiem ; Possible Causes What To Do
Display flashes "bAd" The installed connection o Contact installer or electrician to correct miswire
then "linE" with a from the house to the unit
loud tone is miswired.
Displag goes blank A fuse in gour home meg be ° Replace the fuse or reset the circuit breaker,
blown, or the circuit breaker
tripped.
The clock is turned off from o See the Using the clock and timer section
showing in the displag.
Displag flashes Power failure. • Reset the clock
Unable to get the Oven control pads were ° The Bake and Broil Hi/Lo pads must be touched
displag to show "SF" not pressed properlg, at the some time end held for 3 seconds
Power outage, Power outage or surge° ° Reset the clock. If the oven was in use, gou must reset
clock flashes it bg touching the C'lear/Offpad, setting the clock
and resetting ong cooking function,
"Burning" or "oilg" This is normal in a new oven ° To speed the process, set o self-cleon cgcle for o
odor emitting from and will disappear in time. minimum of 3 hours See the Using the self-cleaning
the vent oven section
Strong odor An odor from the insulation ° This is temporary
around the inside of the
.... oven is normal for the first
few times the oven is used,,
Drawer does not slide The drawer is out of ° Fullg extend the drawer end push it olt the way in
smoothly or drags alignment. See the Care and cleaning of the range section
Drawer is overloaded or load • Reduce weight Redistribute drawer contents
is unbalanced.
Warming/lower oven A fuse in gour home mag be ° RepIace the fuse or reset the circuit breoke_
drawer will not work blown, or the circuit breaker
tripped.
Controls improperlg set. ° See the Worming drawer section
Excessive condensation Liquid in drawer. • Remove liquid
in the drawer
Uncovered foods,, • Cover food with lid or aluminum foil
Temperature setting too high. ° Reduce temperature setting
Food dries out in the Noisture escaping,, • Cover food with iid or aluminum foil,
warming!tower oven
drawer Drawer not fullg closed,, • Push drawer in until latch engages
53