Advertisement
Available languages
Available languages
OTHER SAFETY EQUIPMENT.
Use safety goggles or safety
glasses with side shields, complying
with applicable safety standards
and, when needed, a face shield.
Also use face or dust mask if
cutting operation is dusty. This
applies to all persons in the work
area. Also use a hard hat, hearing
protection, gloves, safety shoes and
dust collection systems when
specified or required.
DON'T ABUSE CORD. Never carry
tool by cord or yank it to disconnect
from receptacle. Keep cord from
heat, oil, and sharp edges.
SECURE WORK.
Use clamps or a
vise to hold work. It's safer than
using your hand and it frees both
hands to operate tool.
DON'T OVERREACH.
Keep proper
footing and balance at all times.
MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for
better and safer performance.
Follow instructions for lubricating
and changing accessories. Inspect
tool cords periodically and if
damaged, have repaired by
authorized service facility. Inspect
extension cords periodically and
replace if damaged. Keep handles
dry, clean, and free from oil and
grease.
DISCONNECT
TOOLS. Unplug the
tool when not in use, when moving
tool from place to place, before
servicing, and when changing
accessories (such as blades, bits,
cutters) or making adjustments.
REMOVE
ADJUSTING
KEYS AND
WRENCHES.
Form habit of
checking to see that keys and
adjusting wrenches are removed
from tool before turning it on.
AVOID UNINTENTIONAL
STARTING.
Don't carry tool with
finger on switch. Be sure switch is
off when plugging in.
STAY ALERT. Watch what you are
operate tool when you are tired or
otherwise
impaired.
CHECK DAMAGED
PARTS. Before
further use of the tool, a guard or
other part that is damaged should be
carefully checked to determine
that
it will operate properly and perform
its intended function. Check for
alignment
of moving parts, binding
of moving parts, breakage of parts,
mounting, and any other conditions
that may affect its operation. A guard
or other part that is damaged should
be properly repaired or replaced by
an authorized service center. Do not
use tool if switch does not turn it on
and off.
REPAIRS AND SERVICE. Repairs,
maintenance
and any adjustments
not specified
in this manual should
be performed by Sears authorized
service centers or other qualified
service organizations,
always using
identical replacement
parts.
USE OF ACCESSORIES
AND
ATTACHMENTS.
The use of any
accessory or attachment not
recommended
for use with the tool
could be hazardous. Note: Refer to
the accessory section of this manual
for further details.
IMPORTANT SAFETY
INSTRUCTIONS (FORBATTERY AND
CHARGER)
, Z_ WARNING:
When using electric
tools, basic safety precautions
should
always be followed to reduce risk of fire,
electric shock, and personal injury,
including the following:
READ ALL INSTRUCTIONS
1.
Do not store or carry battery so that
metal objects can contact exposed
metal end shown in Figure 1. For
example, do not place battery in
aprons, pockets, tool boxes,
drawers etc. with loose nails,
screws, keys, etc. without battery
3
Advertisement
