Craftsman 917.272264 Owner's Manual page 31

Lawn tractor 25.0 hp, 48" mower electric start automatic transmission
Table of Contents

Advertisement

TROUBLESHOOTING
CHART:
Seeappropriatesectionin
manualunlessdire_edto
Searsse_icecenter
CAUSE
CORRECTION
Build-up of grass, leaves
and trash under mower.
.
4. Dirty air filter.
5. Low oil level/dirty
oil.
6. Faulty spark plug.
PROBLEM
Loss of power
continued)
Excessive
vibration
Engine continues
to run when
operator
leaves
;eat with
attachment
:lutch
engaged
Poor cut - uneven
Mower blades will
lot rotate
7. Dirty fuel filter.
8. Stale or dirty fuel,
9. Water in fuel.
10.Spark plug wire loose.
11. Dirty engine air screen/fins.
12. Dirty/clogged muffler.
13.Loose
or damaged wiring.
14.Carburetor out of
adjustment.
15. Engine valves out of
adjustment.
1. Worn, bent or loose blade.
2. Bent blade mandrel.
3. Loose/damaged
part(s).
1. Faulty operator-safety
presence control system.
Worn, bent or loose blade.
Mower deck not level.
Buildup of grass, leaves,
and trash under mower.
Bent blade mandrel.
Clogged mower deck vent
from build-up of grass,
leaves, and trash around
mandrels.
,
2.
3.
4.
5.
.
3. Clean underside of mower
housing.
4. Clean/replace
air filter.
5. Check oil level/change oil.
6. Clean and regap or change
spark plug.
7. Replace fuel filter.
8. Drain fuel tank and refill
with fresh gasoline.
9. Drain fuel tank and
carburetor, refill tank with
fresh gasoline and replace
fuel filter.
10. Connect and tighten spark
plug wire.
11. Clean engine air screen/
fins.
12.Clean/replace
muffler.
13. Check all wiring.
14.See "To Adjust Carburetor"
in Service and Adjustments
section.
15.Contact a Sears or other
qualified service center.
1. Replace
blade.
Tighten blade bolt.
2. Contact a Sears or other
qualified service center.
3. Tighten loose part(s).
Replace damaged
parts.
1. Check wiring, switches
and
connections.
If not corrected
contact a Sears or other
qualified
service center.
1. Replace blade. Tighten
blade bolt.
2. Level mower deck.
3. Clean underside of mower
housing.
4. Contact a Sears or other
qualified service center.
5. Clean around mandrels to
open vent holes.
1. Remove obstruction.
Obstruction in clutch
mechanism.
31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents