Assembly Instructions; Operating; To Raise The Vehicle; To Lower The Vehicle - Craftsman 875.50190 Operator's Manual

2. insert Foot Peda_ Arm @ into the sleeve of Hydraulic Ram _ and
secure wth M8 x 12 Hex Bolt (4)_
3, Attach Height Lock Re_ease @ to Height Lock Bar using 2 Spdng
Washers G8 (1)AND 2 Nuts M8 (2),
4, Attach T-Handle _to ConnectiRg Rod _ with Cotter Pin (3),
5. Make sure that ali connections are tightened thoroughly.
TO RAISE THE VEHICLE (see Figs 2_3)
1, P_ace_ck on a hard ievef surface
2. To a/'_id item from slipping du#ng tP_
_aisingo_ration ONLY litton points d
vehicle ed by vehlcie manufacturer F_t Pedal
in the veh_sWsoperatoCsmanual
under the vehicle s liftpoint.
f@t on tab marked LOCK_AL_YS @ec£ to _ sure #_atthe _dd_e and the
vehicle are p@sit£_edco_Tect_y B EFORE raising the }8_k
5, Use Fc_t Peda_ to raisevehicle, Pump Foot Peda}unti_tip o_Height L_;_ Bar
m_s past desired _c_kpositbn ridge The tip of the Height Lock Bar wit!sink
ilto position just behind the ddge. Depress releasepeda_s_ight_y s o that #'_e tip
movessaugty a_inst _idge
& Apply t}e-down straps (see page 7, Secudng the '_,Lehicle) once _hic_e has been
raised to the desired working he_ht Thoroughly tighten the two tie-®wn straps.
7, Stabiiize _oaded on a hard surface for maximum balance by adjustin9
_ockingscrews
TO LOWER THE VEHICLE, (see Fig, 2)
1, Raise the iack s_ighflyand pull back on the Height L_sk Re_easeto release
2, Fastenthe Height L_k Retease @ tothe Qip @_
3. Pressthe Relea_ Pedal_very gently to lower the Saddle_)and vehicle
6