Table of Contents
Advertisement
GROUNDING
THE GENERATOR
A grounding lug is supplied with the generator for use
when required by local electrical ordinances
Refer to
article 250 of the National Electrical Code to clarify
any needed grounding information
Your local electric
company or a certified electrician should be able to
help you with this information
Grounding Lug
•
Repeat the above steps for the opposite side
•
Insert the threaded stud of rubber foot (10)
through the middle hole of the foot bracket (5)
Secure with lock nut (8) and tighten
•
Locate the support under the electrical outlet end
of the generator
Position foot bracket (5) with
rubber foot installed
under the support and align
the holes in the foot bracket (5) with the slots in
the support
Place one cap screw (9) through each
slot in the support and the holes in the foot
bracket
Secure with the lock nuts (8) and tighten
•
Once completed
the wheel kit is ready for use
NOTE: Your engine is already grounded to the frame
by a grounding strap
6
/
/
/
/
INSTALLING
WHEEL KIT
The Craftsman Wheel Kit was designed to greatly
improve the portability of your generator
Drain gas and oil before
assembling
the portability
kit.
Failure to do so will cause damage
to the
engine.
11
12
NOTE: Always follow state regulations for proper oil
disposal.
•
Place generator on level ground; drain all gas and
oil from the engine (see engine manual for correct
procedure).
•
Place a 1" thick x 1' square piece of wood on the
ground in front of the engine. With the help of
another person, tilt the generator and rest the
recoil starter on the wood. NOTE: This will
support the gasoline engine during assembly and
make assembly easier.
•
Place a handle cap (7) onto each end of handle
prior to installation.
•
The handle should be installed on the electrical
outlet end of the generator.
Place one washer
(12) on long cap screws (11). Align the handle
brackets with the upper holes pre-drilled in the
generator frame. Place mentioned screws through
frame and handle brackets. Secure with lock nuts
(8) and tighten.
•
Locate the engine support.
Place one wheel
bracket (4) on top of support as shown in illustra-
tion. Align with the pre-drilled holes in support.
Place 2 cap screws (9) through holes in bracket
and support. Secure with 2 lock nuts (8) and
tighten.
•
Insert one shoulder bolt (2) into wheel (1). Insert
threaded end of bolt through wheel bracket,
secure with lock nut (3) and tighten. NOTE: The
wheel will
not rub frame if installed
properly.
i
1
\
\
8
10
This portability
kit includes
the following
parts:
Key
No.
Description
PART NO.
1
2
3
4
5
6
7
8
9
10
11
12
Wheel (2 used)
Shoulder Bolt (2 used)
Lock Nut3/8
16(2used)
Wheel Bracket (2 used)
Foot Bracket
Handle
Handle Cap (2 used)
Lock Nut 5/16
18(9used)
Cap Screw5/16
18x3/4"
(6 used)
Isolator Foot
Cap Screw 5/16-18 x 175"
(2 used)
Washer (2 used)
AC-0014
CAC-60
SSF-8111-ZN
GS-0561
GS-0562
GS-0564
GS-0565
SSF-8150
SS-12-CD
GS-0587
SSF-999-1
SS-6506-CD
MGP-679_01
10 -- ENG
Advertisement
Table of Contents
