Advertisement
6. Place the rack (3) in position inside the table support
(6), making sure the worm gear (7) on the inside of
the table support is engaged with the teeth of the
rack.
Fig. E
p
3
'
7
6
7. Slide the table support assembly with the rack (6, 7,
3) together onto the column support (t0).
8. Engage the bottom of the rack (3) with the lip of the
column. Tighten the support lock handle (9) to lock
the table support assembly to the column.
Fig. F
9
6
10
9. Install the collar (2) to the top end of the rack (3) on
the column (10). Tighten the set screw (1).
IMPORTANT: The bottom of the collar MUST NOT
be pushed all the way down onto the top of the rack.
MAKE SURE the top of the rack is under the bottom
of the collar and that there is enough clearance to
allow the rack to freely rotate around the column.
CAUTION: To avoid column or collar damage, DO
NOT OVERTIGHTEN the set screw.
Fig. G
3
10
10.Assemble table (5) to the table support (6) using
the large hex head bolt (4). Hand tighten the hex
bolt. Align the locking pin (t 1) with the
corresponding hole in the table support (6). Turn the
locking pin nut to the outside end of threads. Gently
top the locking pin until it is seated in the hole.
11.Tighten the hex head locking bolt (4) with a socket
wrench, 23mm socket.
12.Finger tighten the small locking pin and nut (11 ), to
lock the table in the 0
horizontal position.
Fig. H
6
1&Thread the table crank handle (12) onto the crank
arm (13) and tighten.
14.Install the assembled
table crank handle (13) to the
shaft (14) on the side of the table support (6).
15.Line up the flat side of the shaft with the set screw
(15) in the crank handle and tighten the screw with a
hex wrench.
Fig. I
14
12
Advertisement
