Craftsman 315.111372 Operator's Manual page 12

TO CHARGE SCREWDRIVER USING
CHARGING STAND
See Figure 6.
• Place screwdriver in charging stand making sure input
jack and charger plug are properly connected.
• Align slots on screwdriver with tabs on charging stand
then push on screwdriver to snap into place.
• Connect charger to power supply.
• After normal usage, a minimum of 10 hours of charging
time is required to fully charge screwdriver.
• Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
SLOTS
CHARGER
ROTATION
HANDLE
Fig. 7
COLLET
See Figure 8.
The co(let on the screwdriver has been designed to accept
1/4 in. hex bits.
TO INSERT BIT
See Figure 8.
Insert bit into collet as far as possible.
INPUT JACK _ COL_,,,_
LIGHT
CHARGING See Figure 9.
Fig. 8
STAND Fig. 6
The screwdriver has a built-in light. This feature is
convenient when working in close or tight areas where
additional light is needed. A slide switch is located on the
bottom of the screwdriver. To turn light ON, push switch
forward. To turn light OFF, pull back on switch.
NOTE: Always turn light off on our screwdriver when not
in use.
LIGHTSWITCH
STICK / PISTOL COMBINATION
SCREWDRIVER
See Figure 7.
The screwdriver has been designed so that it can be used
as a stick screwdriver or a pistol screwdriver. A rotation
button is located on the side of the screwdriver. For driv-
ing screws, depress right side of switch. For removing
screws, depress left side of switch. To place the screw-
driver in pistol position, hold it in normal operating posi-
tion, depress rotation button and push down on handle.
To place the screwdriver in stick position, hold it in normal
operating position, depress rotation button and pull up on
handle.
Fig. 9
LIGHT
12