Install The Door Control - Craftsman 139.53976SRT Owner's Manual

Installation Step 6
Install the Door Control
Locate the door control within sight of the door at a
minimum height of 5 feet where small children
cannot reach, and away from all moving parts of the
door and door hardware.
I
The door control is typically attached directly to the
wall. If installing into drywall, drill 5/32" holes and
use the anchors provided. For pre-wired installations
(as in new home construction), Console models may
be mounted to a standard single gang box.
See illustrations.
1. Strip 1/4" of insulation from one end of the bell
wire. Connect wire to the two screw terminals on
the back of the door control: white wire to 2 and
white/red wire to 1.
2. Remove the push bar cover by gently prying off
the top edge with a coin or screwdriver. Fasten
with 6ABx1-1/4" self-tapping screws (standard
installation) or 6-32xl" machine screws (pre-wired
installation) as follows:
• Install bottom screw, allowing 1/8" to protrude
from the wall.
• Position bottom of door control on screw head
and adjust for snug fit.
• Install top screw with care to avoid cracking
plastic housing. Do not overtighten.
3. (For standard wall mount only)
Run the bell wire up wall and across ceiling to
opener. Use insulated staples to secure wire in
several places. Be careful not to pierce wire with a
staple, creating a short.
4. Connect the bell wire to the terminal screws on
the opener panel: white to 2; white/red to 1.
5. After testing, replace the cover by inserting top
tabs and snapping into place.
Note: After installation, the green indicator light
behind the push bar cover will indicate proper
connection.
The automatic light feature will become functional
1-1/2 minutes after power is restored.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the followin9 two conditions: (t) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Do not connect to live electrical wiring. Connect
only to 24 Volt low voltage wires. Connection to
live wires or higher voltage may cause serious
Injury from shock, burn or electrocution.
Children operating or playing with a garage
door opener can Injure themselves or others.
The garage door could close and cause
serious injury or death. Do not allow children
to operate the push buttons or remote
controls.
A moving garage door could Injure someone
under it. Activate the opener only when the
door is properly adjusted, you can see it clearly,
and there are no obstructions to door travel.
PRE-WIRED INSTALLATION
24 Volt
2-Conductor
Sell Wire
To Replace
Insert Top
Tabs First ..""
Indicator
Light Push Sar Cover
STANDARD WALL MOUNT
To Replace __'D_
Insert Top
Tabs First . -
Oet_or
Switch
ON
Light Push Bar Cover OFF
•
ON
_OFF
Hardware Shown Actual Size
_ lllllllllllllll_lll II Ill]>
6AB x 1-1/4" Screw Insulated
Control Console (std installation) Staples
Control Console (pre-wired) Dry Wall Anchors
Opener Terminal Screws
2-Conductor Push Bar
Bell Wire
Lock
Bu_on
Light BuHon Opener Panel
LAntenna
i
18