Advertisement
Setting
Warmer Drawer Contro/ (ff Equipped)
To Set the Warmer
Drawer
Controls:
The control and indicator lights for the Warmer Drawer features are located on the control panel. The temperatures
are
approximate, and are designated by HI (high), MED (medium) and LO (low).
1. Touch the o_/0f_ (see Fig. 4) pad at the Warmer Drawer control position. The Warmer Drawer indicator light will flash. Note:
If no further pads are touched within 25 seconds the request to power the Warmer Drawer ON will clear.
2. Set the desired power leveI. Touch
A
once to turn ON the power level for Hl (see Fig. 1)or
V' to tum ON the power
3.
level for LO (see Fig. 3). The Warmer Drawer indicator light located beside the _)
pad will turn ON steady.
Each touch of the
V
or
/k
padswilldecreaseorincreasethrough5powerlevelsfromHl(seeFig.
1)toMED(seeFig.
2) to LO (see Fig. 3). Note: For best results, preheat the Warmer Drawer before adding the food. An empty d rawer will preheat
in approximately
15 minutes.
4. When the food is ready for removal, touch the _
pad once to turn the Warmer Drawer OFF.
The Warmer Drawer indicator light will turn OFF.
Note: The Warmer Drawer is inoperable during the self-clean
cycle.
Note: The warmer drawer is equipped with
a latch which may require extra force when
opening and closing the drawer.
hi®
M©
hi©
•
0
0
reed 0
reed ®
reed ©
®
®
©
Io ®
Io •
Io •
Fig.1
Fig. 2
Fig. 3
?
_i;ii!!, i'O_/Otf
Fig. 4
17
Advertisement
