To Remove And Replace Storage Drawer - Frigidaire CFDS3035LS1 Use & Care Manual

Built-in
Hide thumbs Also See for CFDS3035LS1:
Table of Contents

Advertisement

Changing
oven light
Be sure the oven is unplugged and all parts are COOL
before replacing the oven light bulb. Do not turn
the oven light on during a selFdeaning
cycle. High
temperature will reduce lamp life.
On some models an interior oven light will turn on
automatically when the oven is opened. The oven light
may be turned on when the door is closed by using the
oven light switch located on the Electronic Oven control.
The oven light bulb is covered with a glass shield held
in place by a wire holder. THIS GLASS SHIELD MUST
ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.
BESURE OVEN ZS COOL
To Replace the Light Bulb:
1, Turn the power off at the main source.
2.
Wear a leather-faced glove for protection against
possible broken glass.
3.
Replace bulb with a 40
Watt appliance bulb only.
4.
For selFcleaning oven,
press wire holder to one
side to release glass
shield, change bulb and
be sure to replace glass
shield.
To remove and replace storage drawer
Use the storage drawer for storing cooking utensils. The
drawer can de removed to facilitate cleaning under the
range. Use care when handling the drawer.
Removing and Replacing Storage Drawer
To remove
the drawer:
1.
Pull empty drawer out to the roller guide stop.
2.
Tilt the drawer up and pull it out over the rollers.
To replace the drawer"
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the
rollers to clear the roller guide stop, and push in.
Storage
Drawer

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cfds3035ls2Cfds3035ls3

Table of Contents