To Remove And Replace Storage Drawer - Frigidaire CFEF2415LWA Use & Care Manual

Surface Elements and Drip Bowls
Surface elements can be unplugged and removed to
make cleaning the drip pans easier. The surface elements
clean themselves when they are turned on. Food
spilled on a hot element will burn off. Food spilled on a
coo! element may be cleaned with a damp cloth--any
remaining soil will burn off the next time the element is
used. Never immerse a surface element in water.
To Remove the Surface Elements and Drip Bowls
1. Lift up edge of surface element across from terminal
end. Lift just enough to clear edge of the drip bowl.
2. Gently slide the surface element out of the terminal
plug.
3. Lift the drip bowl up and out.
Be sure the range is cool before removing elements or
drip bowls. Be careful not to bend terminal ends when
replacing elements after cleaning.
Hold Su
Down
Terminal End
Plug
To Clean Drip Bowls
Wash in hot, soapy water or in the dishwasher. Rinse
and dry while still warm. Hard to remove, burned on soil
can be removed by soaking the drip bowls for about 20
minutes in a lightly diluted liquid cleanser or a solution
of ammonia and water (1/2 cup ammonia to 1 gallon
of water). A nylon scrubber may be used after soaking.
DO NOT use abrasive cleaners or steel wool, as they will
scratch the surface. Always rinse with clean water and
polish dry with a soft cloth.
To Replace Drip Bowls and Surface Elements
1. Slide the terminal end on the element through the
opening in the drip bowl.
2. Align the element support to rest on the rim inside
the drip bowl. If your drip bowl is equipped with a
hold down clip, align the element support opposite
the terminal end with the slot in the hold down clip,
and snap into place.
3. After the element is positioned in the drip bowl, line
up the terminal end with the terminal plug as shown.
4. Hold the surface element and drip bowl together as
level as possible and firmly push the terminal end
into the terminal plug. Make sure element terminal
is seated properly into terminal plug. Make sure the
surface element is level to reduce the hazard of pans
sliding off the element.
To remove and replace storage drawer
Use the storage drawer for storing cooking utensils. The
drawer can de removed to facilitate cleaning under the
range. Use care when handling the drawer.
Removing and Replacing Storage Drawer
To remove the drawer:
1. Pull empty drawer out to the roller guide stop.
2. Tilt the drawer up and pull it out over the rollers.
To replace the drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the
rollers to clear the roller guide stop, and push in.
Relier
Guide
Storage
Drawer
Front
Frame