Removable Outer Door Glass Panel; To Remove/Replace Storage Drawer - Frigidaire FEFB68CQA Owner's Manual

Hide thumbs Also See for FEFB68CQA:
Table of Contents

Advertisement

Removable Outer Door Glass Panel
(some models)
Applicable only to models with an external glass panel not held with a frame. This design allows you to clean the inside face of the exterior door
panel as well as the hidden face of the door inner glass.
To remove
the external
door glass panel:
1.
Pull the door off the range and lay the door flat.
2.
Using a screwdriver, remove the screws fastening the glass lower metal support rail to the underside of the door.
Remove the support rail.
3.
Grab both sides of the glass panel and slowly pull it out of the door upper moulding. Lay the glass flat.
Handle the glass panel with care. When dropped on a corner the glass panel may shatter in multiple fragments and you
could get hurt.
To replace the external
door panel:
1.
Grab the sides of the glass panel and carefully inselt the glass into the door top moulding.
2.
Replace the glass support rail and the locking screws.
3.
Replace the door onto the range.
To Remove/Replace Storage Drawer
To remove the Drawer:
Push down the left latch
and pult up the right latches,
PuIt drawer out
of range,
To Remove/Replace
the Storage
Drawer
with
Extendable
Glides
(some models)
Use the storage drawer for storing cooking utensils. The drawer can be removed to facilitate cleaning
under the range. Use care when handling the drawen
To Remove the Drawer:
1.
Pull out the empty drawer until it stops.
2.
Push down the left glide latch and pull up the right glide latch.
3.
Pull drawer out of the range.
To Replace the Drawer:
1.
Slide the drawer rails over the glides.
2.
Push the drawer back into the range.
RAILS
To Remove/Replace
the Storage
Drawer
with
Rollers
(some models)
To Remove the Drawer:
1.
Pull the empty drawer out to the roller guide stop.
2.
Tilt the drawer up and pull it out over the rollers.
To Replace the Drawer:
1.
Insert the rear end of the drawer into the opening.
2.
Fit the drawer end rollers onto the guide rails.
3.
Push the drawer in until it stops, then lift to allow the rollers to clear the roller guide stop, and push
in.
General 20 Information

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fefb68csa

Table of Contents