Advertisement
Solutions
to Comrnon
Problems
OCCURRENCE
POSSIBLE
CAUSE/SOLUTION
Oven electronic
control beeps and
displays
"Ff, F2, F3, or F9."
This oven is equipped with a state of the art electronic oven controller. Among the many
features is a full time oven circuit diagnostics system. The controller constantly monitors the
internal circuitry as welt as several crucial oven circuits to insure they are all operating
correctly. If at any time one of these systems fails, the controller witl immediately stop the
current operation and beep continuously
(flashing an error code of "F1, F2, F3, or F9" in the
controller display window.
Electronic control has detected a fault condition. Press CLEAR/OFF
to clear the display and
stop the beeping. Reprogram oven. If fault remains, record fault number. Press CLEAR/OFF
and contact a Servicer.
Oven control
beeps when you try
to enter times or temperatures
Poor baking
results.
The oven control wilt only accept correct responses and/or the minimum number of
aHowab{e entries for the appropriate
feature. The oven control is designed to prevent
accidental entries. Review the instructions
in this Use & Care Manual for the feature you are
trying to use. Also review the minimum and maximum temperature
entries for the feature
you are trying to set on page 15 in this Use & Care Manual.
Many factors affect baking results. Make sure the proper rack position is being used. Center
food in the oven and space pans to allow air to circulate. Altow the oven to preheat to the
set temperature
before placing food in the oven. Try adjusting the recipe's recommended
temperature
or baking time. tf you feel the oven is cooking too hot or cool, see Adjusting
the Oven Temperature
in this Use & Care Manual.
Self-Cleaning
cycle does not work.
Controls are not set properly. Follow instructions
in the Self-Cleaning
section.
The Self-Cban
feature will not operate whenever a radiant surface element is on.
Setf-cbaning
cycle was interrupted.
Stop time must be set for 2, 3_ or 4 hours past the start
time. Foltow steps shown in Stopping
or interrupting
a Self-Clean
Cycle in the Self=
Cleaning
section.
Soil is not completely removed.
Failure to clean bottom front, top of oven or door areas outside oven seal These areas are
not in the Self-Cbaning
area, but get hot enough to burn on food residue. Clean these
areas before starting the self-clean cycle. Burned-on
residue may be cleaned with a stiff
nylon brush and water or a nylon scrubber. Be careful not to damage the oven gasket.
Excessive spilFovers
in oven. Set Self-Clean
cycle for a longer Self-Cbaning
time.
Flames inside oven or smoking
Excessive spilt-overs
in oven. This is normal, especially for pie spill-overs or targe amounts
from vent.
of grease on the oven bottom. Wipe up excessive
spilt-overs before starting the self-clean
cycle. If flames or excessive smoke are present, stop the Self-Cban
cycle and follow the
steps shown in Stopping
or interrupting
the Self-Clean Cycle in the Self-Cleaning
section.
34
Advertisement
