To Remove And Replace Oven Door - Frigidaire FGF364CJSA Owner's Manual

Sealed surface burners, electronic oven control, and a self-cleaning oven interior
Table of Contents

Advertisement

General Cleaning
:ontinued)
The door is heavy. For1
safe, temporary storage, lay the door I
flat with the inside of the door facingI
down.
/
To Remove and Replace Oven Door
To Remove
Oven Door:
1.
Open the door.
2.
Remove screws located on the inside of the oven door near the hinges A
(one on each side.)
3.
Closethedoortothequarter-openposition.
Graspthedoorfirmlyonboth
sides and lift up and off the hinges.
4.
To clean oven door, follow the instructions provided in the cleaning chart
under General
Cleaning
Lift do_r straight off 2 door hinges
Figure 2
To Replace Oven Door:
1.
Be surethe hinge arms are in the quarter-open
position. Becareful if pulling
the hinges open by hand. The hinges may snap back against the oven frame
and could pinch fingers.
2.
Hold the door at the sides near the top. Insert the hinge arms into slots at
the bottom
of the door.
3.
Hinge arms must go into the range slots evenly. The hinge arms should be
inserted into the bottom corners of the door as far as they can go.
4.
Ifthedoor
is not in linewith the oven frame, remove it and repeat the above
steps.
TO Remove
and
Replace
Warmer
Drawer
(if equipped)
To Remove Warmer
Drawer:
1.
_
Turn power off before removing the warmer
drawer.
2.
Open the drawer to the fully opened position.
3.
Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (see figure 1).
5.
Pull the drawer away from the range.
To Replace Warmer
Drawer:
1.
Pull the bearing
glides to the front of the chassis glide (see figure 2).
2.
Align the glide on each side of the drawer with the glide slots on the range.
3.
Push the drawer into the range until levers "click"
(approximately
2"). Pull
the drawer open again to seat bearing glides into position.
If you do not
hear the levers "click"
or the bearing glides do not feel seated remove
the drawer
and repeat steps I thru 3. This will minimize possible damage
to the bearing glides.
l_
1 _
Electrical
Shock Hazard can occurand
result in
serious injury or death.
Disconnect
appliance
from
electric
power before cleaning and servicing the warmer drawer.
16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents