Frigidaire FGF364CJSA Owner's Manual page 19

Sealed surface burners, electronic oven control, and a self-cleaning oven interior
Table of Contents

Advertisement

Oven
does not operate.
Be sure the electronic
oven controls
are set correctly
for the desired function,
See
Setting
Oven Controls
in this Owners
Guide or Entire Appliance
Does Not Operate
(see below).
Be sure regulator gas valve is "ON'. See installation instructions.
Entire appliance does not operate.
Make sure electrical cord/plug is plugged tightly into outlet (electric ignition models
only).
Service wiring not complete. Contact servicer or dealer.
Electrical power outage (electric ignition models only). Check house lights to be sure.
Call your local electric company for service. Surface burners can be lit manually. See
Setting Surface Controls in this Owner's Guide.
Be sure gas supply is turned on.
Cooktop and/or oven light (some models)
Burned-out or loose bulb. SeeChanging Cooktop and/or Oven Lights (some models)
does not work.
section in this Owner's Guide to replace or tighten the bulb.
Oven
smokes
excessively
during
broiling.
Oven door is open. Door should
be closed during broiling.
Meat too close to broil burner. Reposition the rack to provide more clearance between
the meat and the broiler.
Meat not properly prepa red. Remove excessfat from meat. Slashremaining fatty edges
to prevent curling, but do not cut into the lean.
Broiler pan used without grid or grid covered with foil. DO NOT use the broiler pan
without grid or cover grid with foil.
Oven needs to be cleaned.
Grease has built up on oven surfaces. Regular cleaning
is
necessary
when
broiling
frequently.
Old grease
or food
spatters
cause excessive
smoking.
Poor baking results.
Many factors affect baking results. Make sure the proper rack position is used. Center
food in the oven and space pans to allow air to circulate. Allow the oven to preheat to
the set temperature
before placing food
in the oven. Try adjusting the recipe's
recommended temperature
or baking time. If you feel the oven istoo hot or cool, see
Adjusting Oven Temperature in this Owner's Guide.
Self-Cleaning cycle does not work.
Controls are not set properly. Follow instructions under Oven Cleaning.
Self-cleaning cycle was interrupted. Stop time must be set 2 to 4 hours past the start
time. Follow steps under "Stopping or interrupting a Self-Clean Cycle" under Oven
Cleaning.
Soil is not completely
removed.
Failure to clean bottom front, top of oven or door areas outside oven seal. These areas
are not in the self-cleaning
area, but get hot enough
to burn on residue. Clean these
areas before starting the self-clean cycle. Burned-on
residue may be cleaned with a stiff
nylon brush and water or a nylon scrubber. Be careful not to damage
the oven gasket.
Excessivespillovers in oven, Set self-clean cycle for a longer cleaning time.
Flames inside oven or smoking
from vent.
Excessive spilloversin oven. Thisisnormal, especially for pie spilloversor large amounts
of grease on the oven bottom. Wipe up excessive spillovers before starting the self-
clean cycle.If flames or excessivesmokeare present, stop the self-clean cycleand follow
the steps under "Stopping or Interrupting the Self-Clean Cycle" in the Oven Cleaning
section.
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents