Table of Contents
Advertisement
The door is heavy. For
safe, temporary storage, lay the door flat
with the inside of the door facing down.
Changing Cooktop
and/or Oven Lights
(some models)
To Remove and Replace Oven Door
To Remove Oven Door
1. Open the door to the quarter-open position. Grasp the door firmly on both sides
and lift up and off the hinges.
2. To clean oven door, follow the instructions provided in the cleaning chart
under General Cleaning.
To Replace Oven Door
1. Be sure the hinge arms are in the quarter-open position. Be careful if pulling
the hinges open by hand. The hinges may snap back against the oven frame
and could pinch fingers.
2. Hold the door at the sides near the top. Insert the hinge arms into slots at the
bottom of the door.
3. Hinge arms must go into the range slots evenly. The hinge arms should be
inserted into the bottom corners of the door as far as they can go.
4. If the door is not in line with the oven frame, remove it and repeat the above
steps.
Be sure the range is unplugged and all parts are COOL before
replacing the surface or oven lights. Wear a leather-faced glove for protection
against possible broken glass.
To Change the Cooktop Light
For models with 2 Phillips® Head screws that secure the light cover, follow
these instructions:
1. Turn power off at the main source or unplug the range.
2. Remove Phillips® Head screws (2) that secure the light cover and then lift the
light cover off.
3. Remove bulb by rolling back and up. Install the new bulb by sliding down and
rolling forward into place.
4. Re-install light cover and secure with Phillips® Head screws (2).
To Change the Oven Light
On some models, the oven light automatically turns on when the door is opened.
Some models have a switch located on the control panel to turn on the light. The
oven light is located at the rear of the oven and is covered with a glass shield held
by a wire holder. The glass shield must be in place whenever the oven is in use.
To replace the oven light:
1. Turn electrical power off at the main source or unplug the range.
2. Press wire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder into place.
5. Turn power back on again at the main source (or plug the range back in).
6. The clock(if equipped) will then need to be reset. To reset, see Setting the
Clock and Minute Timer in this Owner's Guide.
19
(some models)
(some models)
Advertisement
Table of Contents
