O_N Light - Frigidaire CGLEF384DS2 Use & Care Manual

[nstaMMation [nstructions (continued)
Leveling
For good baking results, your range should be level. Screw type leveling
legs are provided at each corner of tile range at the base. Remove the
storage drawer to adjust the leveling legs. (Refer to Storage Drawer
section).
30" Models 24" Models
(K
LOCKING THE FRONT ROLLERS
(some of the 30" models only)
To [eve[ the range:
1. Use a !-I/4" open end key or an adjustable wrench to equally unscrew the four leveling legs
two to three turns each.
2. Install an oven rack in the center of the oven.
3. Move the range to its final position, then put a spirit level on the rack to check for levelness.
Take two readings, one with the level placed diagonally first in one direction, and then the
other.
4. Use the !-1/4" key or wrench to adjust the leveling legs. Turn each one until the range stands
firm without wobbling.
5. Some models are supported by smooth glide rollers to facilitate moving.
If floor is flat and level, open the drawer and lower the front roller locking levers (some
models) to prevent the range from moving.
If floor is not flat or level or if this model has rollers without locking levers, use the 4 leveling
legs to level, support and prevent the range from moving.
Oven Light
7
Do not turn the oven Hght on during the self-cleaning cydeo High
temperature will reduce [amp [fie,
[
On some models an interior oven light will turn on automatically when tile oven door is opened.
The oven light may be turned on when tile door is closed by using the oven light switch located on
or underneath the control panel.
On a self (:lean oven the lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST BE [N PLACE WHENEVER THE OVEN tS tN USE.
To replace the light bulb:
BE SUREOVEN IS COOL.
1. Turn tile power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield.