Ceramicglass Cooktop (Some Models); Types Of Heating Units Used - Frigidaire CGLEF384DS2 Use & Care Manual

Surface Cooking (continued)
Ceramic Glass Cooktop (somemodels)
Tile (eramic<glass cooktop has electric heating coils located below the ceramic glass surface. The design of the glass cooktop
outlines the area of the surface heating unit below. Most importantly, make sure the diameter of the pan matches the diameter of
the surface unit. Heat is transferred up through the surface of the cooktop. Only flat-bottomed pans should be used. Tile type and
size of the cookware, number of surface units in use and the settings of the surface units are factors that will affect the amount of
heat that will spread to areas surrounding the units. The areas surrounding the units may become hot enough to cause burns.
The cooktop should not be used as a cutting board or work surface. Dropping heavy or hard objects on the cooktop may crack it.
Pans with rough bottoms may scratch the cooktop surface. Placing foods directly on the smoothtop surface (without cooking
utensils) is not recommended as difficult cleaning will result and foods may smoke and cause a potential fire hazard. Never use the
griddle or similar cooking sheet on the ceramic glass cooktop.
Types of heating units used (some models)
Depending on model, three types of heating units may be found under the ceramic glass cooktop:
- Regular (single coil) radiant elements of various diameters or shapes.
- Expandable type (double circuits) radiants elements of various diameters or shapes.
- Bridge Expandable type (triple circuits) radiants elements of various diameters or shapes.
OFF
Regular radiant elements (some models)
The ceramic glass design shows the location of the heating surfaces.
Control knobs are used to set the heat power levels; knobs need first to be pressed in when at
OFF position, then turned to the desired heat settings.
A glowing red surface unit extending beyond the bottom edge of the cooking utensil indicates
the utensil is too small for the unit. Tile control knob does not have to be set exactly on a
particular mark. Use tile marks as a guide and adjust the control knob as needed. The hot
surface and surface indicator lights will glow.
ExpandaMe radiant elements (some modets}
This heating unit combines the characteristics of a small and a large regular radiant heating unit.
Its principal advantage is to allow small and large utensils to be used on the same heating unit,
therefore increasing the cooktop flexibility.
Heat power levels are adjusted by a special control knob that has a dual set of graduations; for
small utensils use the small graduations; the inner surface only will be heating. For larger utensils
use the larger graduations; the whole surface will be heating.
The hot surface and surface indicator lights will glow when the heating unit is turned ON.
OFF
L_n
mir_
Front Bridge
Element Element
graduations graduations
Bridge Radiant elements (some models}
Its principal advantage is to allow you to create larger cooking zone for larger pan such as
roaster, griddle or some other specialty pans.
To use the bridge element, turn the control knob on left side, to the bridge element settings.
For full bridge element operation turn on the rear element.
To use only the front element, turn the control knob on right side, to the front element settings.
Note: Appearance and
graphics of controls may be
differents
10