Craftsman 580.750900 Operator's Manual page 77

ENGINE TECHNICAL iNFORMATiON
This is a single cylinder, L-head, air cooled Model 100000
engine. The Emission Control System for this pressure
washer is warranted for standards set by the Environmental
Protection Agency and the California Air Resources Board.
Certification does not grant the purchaser, owner or operator
of this engine any additional warranties with respect to the
performance or operational life of this engine. The engine is
warranted solely according to the product and emissions
warranties stated elsewhere in this manual.
Power Ratings
The gross power rating for individual gas engine models is
labeled in accordancewith SAE (Society of Automotive
Engineers) code J1940 (Small Engine Power & Torque
Rating Procedure), and rating performance has been
obtained and corrected in accordancewith SAEJ1995
(Revision 2002-05). Torque values are derived at 3060 RPM;
horsepower values are derived at 3600 RPM. The gross
power curves can be viewed at
www.BRIGGSandSTRATTON.COM. Net power values are
taken with exhaust and air cleaner installed whereas gross
power values are collected without these attachments. Actual
gross engine power will be higher than net engine power and
is affected by, among other things, ambient operating
conditions and engine-to-engine variability. Giventhe wide
array of products on which engines are placed, the gas
engine may not develop the rated gross power when used in
a given piece of power equipment. This difference is due to a
variety of factors including, but not limited to, the variety of
engine components (air cleaner, exhaust, charging, cooling,
carburetor, fuel pump, etc.), application limitations, ambient
operating conditions (temperature, humidity, altitude), and
engine-to-engine variability. Dueto manufacturing and
capacity limitations, Briggs & Stratton may substitute an
engine of higher rated power for this Series engine.
PRODUCT SPECIFICATIONS
Pressure Washer Specifications
Outlet Pressure .......................... 2,200 PSI*
Flow Rate................................. 1.8 GPM
Detergent Mix ........................ Use as directed
Water Supply Temperature .......... Not to exceed 100%
EngineSpecifications
Bore ............................. 2.562 in. (65.08mm)
Stroke ............................ 1.875 in. (47.65mm)
Displacement ......................... 9.67 in. (158 cc)
SparkPlug
Type: ............... Briggs & Stratton 802592 or 5095
SetGapTo: ...................... 0.030inch (0.76mm)
Armature Air Gap: ........... 0.006-0.010in.(0.15-0.25mm)
Valveclearancewith valve springs installedand piston 1/4 in.
(6 mm) past top deadcenter (checkwhen engine is cold).
intake .................... 0.005-0.007 in.(0.13-0.18mm)
Exhaust .................. 0.007-0.009 in.(0.18-0.23mm)
FuelCapacity............................... 1.0 Quarts
0il Capacity....................... 18 Ounces(0.53 liter)
NOTICE For practical operation, the engine load should not
exceed85% of rated power. Engine power will decrease
3-1/2% for each 1,000 feet (300 meters) above sea level and
1% for each 10° F (5.6° C) above 77° F (25° C). it should
operate satisfactorily at an angle up to 15°.
* This pressure washer is rated in accordanceto the
Pressure Washer Manufacturers Association (PWMA)
standard PW101-2010 (Testing and Rating Performance of
Pressure Washers).
17