Craftsman 580.750900 Operator's Manual page 73

8. Move throttle lever (A) to "Fast" _ position, shown as
a rabbit.
To start the engine for the very first time:
9A. Push primer bulb firmly 5 times, waiting 2 seconds
between each push.
To start engine thereafter:
9B. Press primer bulb firmly 3 times, waiting 2 seconds
between each push. For a warm engine, DONOT press
primer bulb.
NOTICE Before starting the pressure washer, be sure you
are wearing safety goggles as described below.
,_. WARNING Risk of eye injury.
Spray could splash back or propel objects
resulting in serious injury.
• Always wear indirectvented (chemical splash) safety goggles
marked to comply with ANSI Z87.1 when using or in vicinity of
this equipment.
• NEVERsubstitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
10. When starting engine, position yourself as
recommended and grasp starter grip handle and pull
slowly until you feel some resistance.Then pull rapidly
to start engine.
,_, WARNING Starter cord kickback (rapid retraction) will
puii hand and arm toward engine faster than you
_t,._< can let go which could cause broken bones,
fractures, bruises, or sprains resulting in serious
injury.
• NEVERpull starter cord without first relieving spray gun
pressure.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• After each starting attempt, where engine fails to run, always
point spray gun in safe direction, press red button and squeeze
spray gun trigger to releasehigh pressure.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
13