Craftsman 917.28926 Operator's Manual page 28

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center
PROBLEM
Hard to start
Engine will not
turn over
Engine clicks but
will not start
10
1
2
3
4
5
CAUSE
Carburetor out of adjustment.
Engine valves out of adjustment.
Loss of power
6
7
1
2
3
4
5
6
7
8
9
1
2
3
4
1
4
5
6
7
8
Dirty air filter.
Bad spark plug.
Weak or dead battery.
Dirty fuel filter.
Stale or dirty fuel.
Loose or damaged wiring.
Carburetor out of adjustment.
Engine valves out of adjustment.
Brake pedal not depressed.
Attachment clutch is engaged.
Weak or dead battery.
Blown fuse.
Corroded battery terminals.
Loose or damaged wiring.
Faulty ignition switch.
Faulty solenoid or starter.
Faulty operator presence
switch(es).
Weak or dead battery.
Corroded battery terminals.
Loose or damaged wiring.
Faulty solenoid or starter.
Cutting too much grass/too fast.
Throttle in "CHOKE" position.
Build-up of grass, leaves and
trash under mower.
Dirty air filter.
Low oil level/dirty oil.
Faulty spark plug.
m
9
10
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
9
1
2
3
4
1
2
CORRECTION
See "To Adjust Carburetor" in
Service and Adjustments section.
Contact a Sears or other qualified
service center.
Clean/replace air filter.
Replace spark plug.
Recharge or replace battery.
Replace fuel filter.
Empty fuel tank and refill tank with
fresh, clean gasoline.
Check all wiring.
See "To Adjust Carburetor" in
Service and Adjustments section.
Contact a Sears or other qualified
service center.
Depress brake pedal.
Disengage attachment clutch.
Recharge or replace battery.
Replace fuse.
Clean battery terminals.
Check all wiring.
Check/replace ignition switch.
Check/replace solenoid or starter.
Contact a Sears or other qualified
Dirty fuel filter.
Stale or dirty fuel.
28
3
4
5
6
7
8
Clean underside of mower
housing.
Clean/replace air filter.
Check oil level/change oil.
Clean and regap or change spark
plug.
Replace fuel filter.
Empty fuel tank and refill tank with
fresh, clean gasoline.
service center.
Recharge or replace battery.
Clean battery terminals.
Check all wiring.
Check/replace solenoid or starter.
Raise cutting height/reduce
speed.
Adjust throttle control.