Table of Contents
Advertisement
UNPACKING
,t_
This product has been shipped completely assembled.
[] Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing
list are included.
[] Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
[] Do not discard the packing material until you have
carefully inspected and satisfactorily
operated the
product.
[] If any parts are damaged or missing, please call
1-800-932-3188
for assistance.
PACKING
LIST
Screwdriver
Bit Set
Case
Charger
Operator's Manual
WARNING:
If any parts are damaged or missing
do not operate this product until the parts are
replaced. Failure to heed this warning could result in
serious personal injury.
WARNING:
Do not attempt to modify this product
or create accessories not recommended
for use with
this product. Any such alteration or modification
is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
To prevent accidental starting that
could cause serious personal injury, always remove
the battery pack from the product when assembling
parts.
A
WARNING:
Do not allow familiarity with products to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
A
WARNING:
Always wear safety goggles or safety
glasses with side shields when operating products.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
APPLICATIONS
You may use this product for the purposes listed below:
[] Driving screws with screwdriver bits
[] Light-duty drilling
CHARGING
THE SCREWDRIVER
See Figure 2.
This tool has been shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
it overnight prior to use. When charging the screwdriver,
a red charge light will illuminate on the charger. This
red charge light will go off when the screwdriver is fully
charged.
NOTE: Batteries will not reach full charge the first time
they are charged. Allow several cycles (driving screws
followed by recharging) for them to become fully charged.
If the charger does not charge the screwdriver under
normal circumstances,
return both the screwdriver and
charger to the nearest Sears or other qualified service
center for electrical check.
INPUT
JACK
CHARGERPLUG
Fig. 2
Hide quick links:
Advertisement
Table of Contents
