Craftsman 351.217590 Operator's Manual page 4

INSTALL DUST CHUTE
Refer to Figure 5.
• Slide dust chute over fan housing. Secure in position with
screw.
° Attach the Half Bag Dust Collection Set (included) only
after mounting planer to stand or workbench.
° A 4" diameter dust collection hose (not included) can be
also attached to the outer port.
Figure 5 - Installing Dust Chute
MOUNT PLANER TO STAND
Refer to Figure 6.
CAUTION: Planer weighs approximately 100 Ibs. Two people
may be required to lift planer.
° Planer is designed to be portable so it can be moved to
job site, but should be mounted to a stand or workbench
for stability.
• Make sure stand is located on a firm, level surface in a
place with ample lighting and correct power supply.
° Make sure there is plenty of room for moving the work-
piece through the entire cut. There must be enough room
that neither the operators or bystanders will have to stand
in line with the wood while using the tool.
• The base of the planer has four mounting holes, two in
front (shown in Figure 6) and two in the rear.
Figure 6 - Planer Mounting Holes (Front)
° Mount planer to workbench or tool stand (see Recom-
mended Accessories, page 17) using bolts, flat washers
and hex nuts (not supplied).
° Figure 7 shows the base dimensions and mounting hole
dimensions of the planer.
3/8_f
Dia.
J
T
11%"
15"
25W'
Figure 7 - Base and Mounting Dimensions
INSTALL THE HALF BAG DUST COLLECTION SET
Refer to Figure 8.
The Craftsman Half Bag Dust Collection Set is designed
to provide dust collection for woodworking tools with a 2_/2 ''
diameter dust exhaust port. The filter bag attaches to a
30-gallon trash can or a 30-gallon x 1.3 mil plastic trash
bag for easy, convenient sawdust disposal (trash can and
plastic trash bag not included).
• Mount planer to stand before installing Dust Collection Set.
To use dust collection set with a trash can:
• Place spring inside filter bag arm.
• Slide arm with spring over dust chute.
• Place band of the bag over rim of trash can and secure
bag by tightening strap.
To use dust collection set with a trash bag:
• Place spring inside filter bag arm.
• Slide arm with spring over dust chute.
• Assemble bag support. Slide connectors into channels of
support segments.
• Slide plastic trash bag inside and over bag support. Let
bag overlap 3-4".
• Place band of the filter bag over and into the channel of
the bag support.
• Secure in position by tightening strap.
Spring _.,_ Dust Chute
Filter _ _¢_" Support
Segments
Connector
Band "_ P 5_ j Support
Trash _ J
Can f
Figure 8 - Half Bag Dust Collection Set
4