Advertisement
•
Loosen hex nuts (Key. No. 56) on hex head bolts
(Key. No. 64). Pivot motor mount plate (Key. No. 63)
towards head.
• Slip variable speed belt (Key. No. 46) off spindle pul-
leys (Key. Nos. 34 and 35).
•
Remove belt from motor pulleys. The lower motor
pulley (Key. No. 50) may need to be pushed down to
remove belt.
•
Slide new belt between upper and lower motor pul-
leys (Key. Nos. 49 and 50).
•
Slide lower motor pulley do_n and place belt
between pulleys as close to motor shaft as possible.
•
Slide belt between spindle pulleys on one side.
•
Rotate upper spindle pulley and belt by hand to slide
belt between pulleys. Be careful not to pinch fingers
between pulley and belt.
•
Pivot motor away from head and secure position with
hex nuts.
•
Replace pulley cover, plastic cover and handwheel.
•
Rotate speed change handwheel firmly counter-
clockwise until resistance is felt.
CLEAN
MOTOR
Frequently blow out any dust that may accumulate
inside motor, If power cord is worn, cut or damaged in
any way, have it replaced immediately. For motor lubri-
cation, follow instructions on motor plate,
7
Advertisement
