Advertisement
VACUUM
ASSEMBLY
VACUUM
BAG ASSEMBLY
1. Open tile zipper on the vacuum
bag and insert the elbow tube.
2.
Push the small end of the elbow
tube through the small opening
in
the bag.
Elbow
Tube
Small
Opening
Zipper
Opening
Rib
NOTE: Make sure edge of the small
opening
is flush against the flared area
of the elbow tube, and the rib on the
elbow tube is on the bottom.
3.
Close the zipper on the bag. Make
sure the zipper is closed completely.
4.
Remove blower tube from engine.
i
Rib
5.
Insert the elbow tube into the blow-
er outlet.
Make sure elbow tube is
aligned
with the blower outlet
groove.
6. Turn clamp knob clockwise
to tight-
en.
VACUUM TUBE ASSEMBLY
1. Align tile lower vacuum
tube as
shown. Push lower vacuum tube
into upper vacuum tube.
Upper
Vacuum Tube
Lower
Vacuum Tube
2.
Insert a screwdriver
into the latch
area on the vacuum
inlet cover.
[L_,_
_ _'-_
BlOwer
] _,,
Outlet
,_ ,.a_"
Latch Area
vacuum
/
Inlet Cover
3.
Gently tilt the handle of the screw-
driver toward the back of the unit
while pulling up on the vacuum
in-
let cover with your other hand.
4.
Hold the vacuum inlet cover open
until upper vacuum tube is installed.
Vacuum Inlet
Retaining Post
X/_
wouo
Inlet
_._7,_q_-_
Cover _.._
5. Place the hooks on the vacuum tube
on the retaining posts; pivot tube into
position. Secure vacuum tube by
turning the knob clockwise until tight.
Hooks
6. When converting
back to the blow-
er feature, make sure latch on the
vacuum
inlet cover is securely fas-
tened.
-5-
Advertisement
