Fisher & Paykel AquaSmart WL37T26C Installation Instructions And User Manual page 42

So ving operating prob em, s
Is the power switched on at the wall7
Unplug from walk Wait 60 seconds, plug back in, turn on and try agaim
Could household power supply be at fault7 Try plugging in another appliance_
Key Lock Mode may be activated. Try holding down the POWER button for 3 seconds (refer to
page 34).
Are both hot and cold faucets turned on?
Are the inlet hose filters blocked7 Check the ends of the hoses.
Ensure drain hose is located in standpipe or set tub/sinL
Ensure standpipe or set tub/sink is at least S3 YY'(850 ram) high and no more than
96" (2438 ram) high.
Check that the washer is not siphoning (refer to page 9).
Ensure load is not out of balance
Check washer is level and does not rocL
Ensure washer does not have suds buildup.
Check that the washer is not siphoning (refer to page 9).
Clothes are unevenly distributed in wash tub, your washer has slowed the spin to compensate.
",,!ourwasher is designed to automatically sense load size and minimize water use, therefore the
water level may look different to your previous washer, this is normal.
This unique wash system uses two wash phases. The second phase can be cooler than the first to
minimize energy use. This is normal and will not affect wash performance.
Ensure that you are using a High Efficiency (HE) detergent.
Try using a little less detergent, especially if garments are only lightly soiled.