Table of Contents
Advertisement
Available languages
Available languages
Before you
service
'four cold water temperature
may exceed the recommended
limits (refer to
Installation
instructions
pages 6 - 11 ).
Check that the inlet hose filter is not b[ockeG
Check that the inlet hose is not kinked or squashed.
Check that the inlet hoses have been connected
to the co_ect faucets.
The flow rate of the supply water may be too slow.
©
freely.
Checkthat
the washer is not siphoning
(refer to page 9).
'four washer has a suds build-up. Tbo much detergent
may have been used for the
amount
of soil in the load.
Rinse clothing
using the RINSEand SPIN cycle, or run through
another cycle
For a bulky bad, press down as far as possible and press START/PAUSE_
Check that the lid is c[oseG
If the symptom persists, ca[[ your Fisher and Payke[Dealer or Authorized Service
Center,
Single beep every second and o.°
3.
Check your washer is level (refer to installation
instructions
pages 6 - 11 ).
4.
Remove bad and retry.
5.
Put through
a RINSEand SPIN cycle.
:: 6.
If the fault re-occurs repeat steps 1 and 2.
If the washer still wi[[ not work, ca[[ your Fisher & Payke[ Dealer or Authorized
Service Agent to
arrange service (refer to page 40).
Advertisement
Table of Contents
