Advertisement
RULES FOR SAFE OPERATION (Continued)
20. AVOID ACCIDENTAL
STARTING,
Don't carry
plugged-in tools with finger on switch. Be sure
switch is off when plugging in.
21. MAKE SURE YOUR EXTENSION CORD IS IN
GOOD CONDITION,
When using an extension
cord, be sure to use one heavy enough to carry the
current your product willdraw. An undersized cord
will cause a drop in line voltage resulting in loss of
power and overheating. A wire gage size (A.W.G.)
of at least 16 is recommended for an extension
cord 100 feet or less in length. A cord exceeding
100 feet is not recommended. If in doubt, use the
next heavier gage. The smaller the gage number,
the heavier the cord.
22, OUTDOOR USE EXTENSION CORDS.When tool
is used outdoors, use only extension cords suitable
for use outdoors. Outdoor approved cords are
marked with the suffix W-A, for example - SJTW-A
or SJOW-A.
23. KEEP BITS CLEAN AND SHARP, Sharp bits
minimize stalling and kickback.
24. KEEP HANDS AWAY FROM DRILLING AREA.
Keep hands away from bits. Do not reach
underneath work whilebit isrotating. Do not attempt
to remove material while bit is rotating.
25. NEVER USE IN AN EXPLOSIVE ATMOSPHERE.
Normal sparking of the motor could ignite fumes.
26. INSPECT TOOL CORDS PERIODICALLY
and if
damaged, have repaired at your nearest Sears
Repair Center. Stay constantly aware of cord
location.
27. INSPECT EXTENSION CORDS PERIODICALLY
and replace if damaged.
28. KEEP HANDLES
DRY, CLEAN,
AND FREE
FROM OIL AND GREASE. Always use a clean
cloth when cleaning. Never use brake fluids,
gasoline, petroleum-based products or any strong
solvents to clean your tool.
29. STAY ALERT. Watch what you are doing and use
common sense. Do not operate tool when you are
tired. Do not rush.
30. CHECK DAMAGED PARTS. Before further use of
the tool, a guard or other part that is damaged
should be carefully checked to determine that itwill
operate properly and perform its intended function.
Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and
any other conditions that may affect its operation.
A guard or other part that is damaged should be
properly repaired or replaced by an authorized
service center unless indicated elsewhere
in this
instruction manual.
31.
DO NOT
USE TOOL
IF SWITCH
DOES
NOT
TURN IT ON AND OFF. Have defective switches
replaced by an authorized
service center.
32.
DRILLING
INTO
ELECTRICAL
WIRING
IN
WALLS
CAN CAUSE
DRILL
BIT AND CHUCK
TO BECOME
ELECTRICALLY
LIVE. Do not touch
the chuck or metal housing when drilling into a wall;
grasp only the insulated handle(s) provided on the
tool.
33.
INSPECT
FOR and remove all nails from lumber
before drilling.
34.
DRUGS,
ALCOHOL,
MEDICATION.
Do not
operate
tool while under the influence
of drugs,
alcohol, or any medication.
35.
WHEN
SERVICING
USE
ONLY
IDENTICAL
CRAFTSMAN
REPLACEMENT
PARTS.
36.
POLARIZED
PLUGS.
To reduce the risk of electric
shock, this tool has a polarized plug (one blade is
wider than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully in
the outlet, reverse the plug. if it still does not fit,
contact a qualified electrician to install the proper
outlet. Do not change the plug in any way.
37.
SAVE
THESE
INSTRUCTIONS.
Review
them
frequently
and use them to instruct others who may
use this tool. If you loan someone
this tool, loan
them these instructions also.
Page 3
Advertisement
