One-Piece Door - Craftsman 139.53963SRT Owner's Manual

ONE-PIECE Door Without Track
Read the Safety Instructions on page 12. They also apply to doors without tracks.
• Close the door and mark the inside
vertical centerline of your garage door.
Extend the line onto the header wall
above dour.
If headroum clearance is minimal, you
can install the header bracket on the
ceiling. See page 14.
• If you need to install the header
bracket on a 2x4 (on wall or ceiling),
use lag screws (not provided) to
securely fasten the 2x4 to structural
supports us shown.
OPTIONAL CEIUNG MOUNT
FOR HEADER BRACKET
• Open your door to the highest point of
travel as shown. Measure the distance
from the top of the door to the floor.
Subtract the actual height of the dour.
Add 8" to the remainder. (See
Example).
• Close the dour and draw an
intersecting horizon_l line on the
header wall at the determined height.
If the total number of inches exceeds
the height available in your garage,
use the maximum height possible, or
refer to page 14 for ceiling
installation.
Proceed to Step 2, page 14.
Door
Jamb
Hardware
Header WaU
_/Hlghe_Po_t
Header Highest Pokl|
Wall ofTravel
'4
i
One-piece door without track
jamb hardware
One-place door without track
pivot hardware
EXAMPLE
Distance from top of door
(at highest point of travel) to floor ............. 92"
Actual height of door ...................... -88"
Remainder ................................ 4"
Add .................................... +8"
Bracket height on header wall ................ =12"
(Measure UP from top of CLOSED door.)
13