Fasten The Door Bracket (One-Piece Door) - Craftsman 139.53491SRT Owner's Manual

Please read and comply with the warnings and reinforcement instructions on page 24. They apply
to one-piece doors also.
Header Wall
Header
Bracket
Optional
Placement
of Door
Bracket
• Center the bracket on the top of the door, in line with
the header bracket as shown. Mark holes.
• Drill 5/16" pilot holes and fasten the door bracket with
hardware supplied.
If the door has no exposed framing, drill 3/16" pilot holes
and fasten the bracket with 5/16"x1-1/2" lag screws (not
supplied) to the top of the door.
The door bracket may be installed on the top edge of
the door if required for your installation. (Refer to the
dotted line optional placement drawing.) Drill 3/16"
pilot holes and substitute 5/16"x1-1/2" lag screws (not
supplied) to fasten the bracket to the door.
All ONE-PIECE Door Installation Procedure
Finished Ceiling
2x4 Support
Door
Bracket
Vertical
Centerline of
Garage Door
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fiberglass, aluminum, steel,
door with glass panel, etc.).
Nut
5/16"-18
Door
Bracket
For a door with no
exposed framing or for
the optional installation,
use 5/16"x1-1/2" lag
screws (not supplied)
to fasten door bracket.
Hardware Shown Actual Size
Nut 5/16" - 18
25
Lock Washer
5/16"
Top of Door
(Inside Garage)
Top Edge
of Door
Optional
Placement
Carriage Bolt
5/16"-18x2-1/2"
Lockwasher 5/16"
Carriage Bolt
5/16"-18 x 2-1/2"