Craftsman nEXTEC 320.30566 Operator's Manual page 12

4.. Align the grooves on the
circular grout disc with the
four rai_d ribs on the drive
shaft; sut the at ilication tool
onto the drive shaft (Fig. 23)_
5,. With your gloved hand holding
the blade, insert and dem_ress
the range bert unti_you hear a
click indicating that the circular
grout di_ is secured.
6_ Pressthe ouick°re_ease lever
with your palm to mockthe
driver shaft (Fig. 10)o
NOTICE; The ribs o_r_ t he
shaft and the grooves in the
application tools permit a firm
conr_ection of the a wmlicadon
tools in increments of 45 ° around
the shalL, from 0° to 315 ° (Fig.
24). Aiily the aH_ication tool in
the orientat ion a _ ere wriate to the
task at hand.
CU_ING GROUT WITH
THE CARBIDE CIRCULAR
BLADE (Fig, 24}
1. Insertthe battery ,ack inLo
the multi-tool.
2 Draw the cutting lines on
the work siece.
Fig, 23
F_g. 24
(®)
,[,:
D
3_
Turn on the tool and altow
it to come to the full
desired sieed.
F_g. 25
4. Place the carbide circular
blade against the work tiece
at a 90 ° angle.
5. Cut out the grout around
the tile, then use a hand
chisel to remove the tile
from the wall.
NOTICE: When cutting grout,
masonry and iorous cement,
take into consideration that the
appnication teems/accessories
wear heavily when used for longer ieriods of time.
30566 Ma_uaLRe'_ sod 11-O715
SCRAPER BLADE (67652)
DESCRIPTION (Fig. 26)
Steel scrasing blade
designed for saint &
varnish, bonded cariet, soft
adhesives, vinyl flooring,
wood and other
floor coverings.
Scra|er blade is also
com|atible with the Fein
Mu ItioMaster tool.
TO INSTALL THE
SCRAPER BLADE
Fig. 26
_, CAUTION: For all work
or when changing amilication
tool, a_wayswear trotective
gloves. The share edges of
the a s|lication tool will cause
_ersonal in}uryoAmslication tool
can be very hot while working.
WARNING: Do not attach
the scraper blade f_cing
backwards (Fig 27), which may
hurt the user.
WARNING: Check that
the a | |licadon tool is correctly
attached. Incorrect or insecurely
fastened a i.tlication tool can
come loose during oleration and
cause a hazard.
,
,
Remove the battery sack
from your mu_tiotOOl.
Push the (-uick-re[ea_ lever
fully o|en with your talm to
loosen the flange bo_t(Fig°
28). Remove the flange bo_to
Fig°27
Fig° 28
3. Ensure that the inner threads and the drive shaft are clean.
Page 22 30566 ManuaLRev sod 1I 0715 Page 23