Craftsman 315.105050 Owner's Manual page 6

OPERATION (Cont.)
INSTALLING AUXILIARY HANDLE
See FIQuresl and _
AN AUXILIARY HANDLE IS PACKED WITH YOUR DRILL
FOR EASE OF OPERA'nON AND TO HELP PREVENT
LOSS OF CONTROL. To install, start the screw threads into
the threaded hole in the gear housing and tighten securely.
NOTE: For convenience the screw has been trapped inside
the auxilian/handle.
To prevent thread damage and possible loss of control,
auxiliaP/handle shouldbe checked periodically for tightness,
DO NOT operate drillwith handle loose,
INSTALLING "D" SHAPED HANDLE
See Figure 3.
A multi-position"D" shaped handle is aJsopacked with your
ddll. It is used for maintaining proper balance and control of
your drill,To install, place handle in desired position on star
shaped mounting boss, Mounting bess is located on the end
ofyour ddll. Add washer then insert screw. TO tighten screw,
insert screwdriver through side of handle as shown in figure
3, Tighten screw securely, then remove screwdriver.
INSTALLING BITS
See Figures 4 & 5.
1. UNPLUG YOUR DRILL.
2, Insert dritl bit into chuck the full length of the
Jaws as shown in Figure 4,
3. Using the chuck key provided, tighten chuck Jaws
securely on drill bit. DO NOT USE A WRENCH
TO TIGHTEN OR LOOSEN THE CHUCK,
4, Remove chuck key.
REMOVING BITS
1. UNPLUG YOUR DRILL.
2. Using the chuck key provided, loosen chuck jaws
from drill bit. DO NOT USE A WRENCH TO TIGHT,
EN OR LOOSEN THE CHUCK,
3. Remove drill bit from chuck jaws.
4, Remove chuck key.
THREE LOCATIONS TO INSTALL AUXILIARY
HANDLE
Fig, 2
STAR.SHAPED MOUNTING BOSS
DRILL BIT
Page 6