Charging Battery Pack - Craftsman 315.220730 Owner's Manual

Two speed / reversible 10 mm (318 in.) cordless drill
Table of Contents

Advertisement

A
WARNING: Always wear safety gogglesor
safety glasses with side shieldswhen operating
tools. Failure to do so could result in objects
being thrown Intoyour eyes, resultingin possible
sodous injury,
_k
WARNING:
Do not allow familiaritywith your
drillto make you careless. Remember that a
saraless fraction of a second is sufficientto inflict
severe injury.
CHARGING
BATTERY PACK
The battery pack for this tool has been shippedin a
low charge conditionto prevent possible problems.
Therefore, you shouldcharge it at least 5 hours prior
to use,
Note: Batteries will not reach full charge the first time
they are charged, Allow several cycles (drilling
followed by recharging)for them to become fully
charged,
TO CHARGE
Charge battery peck onlywith the charger
provided,
Make sure power supply is normal house
voltage, 120 volts, 60 Hz, AC only.
Connect charger to battery pack by inserting
charger plug into inputJack.As shownin figure 1,
inputjack is located on the beck side of battery
pack.
Note: Battery pack can remain on your ddll or be
removedwhile charging.When battery peck Jsout
of the ddll, be careful not to touch beth terminals
with a metal object. Touchingbothterminals with a
metal objectwill shortout the battery pack.
Make sure charger plug and inputjack are properly
connected.
Connect charger to power supply,
When properlyconnected, the red lighton battery
peck will turn on,
Note: If charger does not charge battery pack,
return battery pack and charger to your nearest
Sears Repair Center for electrical check.
After normal usage, 3 hours of chargingtime is
requiredto be fully charged.A minimumcharge
time of 5 hoursis required to recharge a completely
dischargedtool.
The battery pack will become slightlywarm to the
touchwhile charging.This is normal and does not
indicate a problem.
Do not operate the toolwhile it is connected to the
charger.The drivingability will not increase.
Do not place charger in an area of extreme heat or
cold. It willwork best at normal roomtemperature.
_.
CAUTION: Your drilrs battery pack contains
special high temperature bettedes to help prevent
battery damage when lefton charge for extended
pedods of time. However, once the bettedes
become fully charged, we recommendthat you
unplugyour charger from power supplyand
disconnectit from the battery pack.

Advertisement

Table of Contents
loading

Table of Contents