Craftsman 580.676641 Operator's Manual page 6

Yourpressure washer requires s omeassembly a ndis
readyforuseonlyafterit hasbeenproperly serviced
withtherecommended oil andfuel.
if you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
iMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure,
Unpack the Pressure Washer
1. Remove everything from carton except pressure
washer.
2. Open carton completely by cutting each corner
from top to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
The main unit
Handle
High pressure hose
Spray gun
Nozzle extension with adjustable nozzle
Turbo nozzle
Wheel kit
Safety goggles
Engine oil
Parts bag (which includes items listed below)
Operator's manual
Become familiar with each piece before assembling
the pressure washer. Compare contents against the
view on page 5. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Attach handle to main unit.
2. Install wheel kit.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect high pressure hose to spray gun and pump.
6. Connect water supply to pump.
Attach Handle
1. Place plastic adapters in hinges on handle
extension as shown.
._-_ \
NOTE: Make sure lip on plastic adapters is facing up
in hinges.
2. Clamp handle extension onto pressure washer
handle and insert T-bolts into holes of clamp.
Tighten by hand.
Install Wheel Kit
The wheel kit is designed to greatly improve the
portability of your pressure washer.
NOTE: Wheel kit is not intended for over-the-road use.
Install the wheel kit as follows:
1. Place the bottom of the pressure washer frame on a
fiat, even surface, such as blocks to ease assembly.
2. Spread axle brackets apart and place over front
vibration mounts on the pressure washer frame as
shown.
,
Squeeze axle brackets back to original shape.