Advertisement
•
Placetheassembled c artcoverontopofthecart,
aligning theboltsinthetopsupport a nglewiththe
holesinthecart.Assemble f ive1/4"flanged nutsonto
thebolts. D ONOTTIGHTEN YET.Seefigure23.
Attach thebottom ofthebraces tothetopsupport
angleandthecartusing two1/4"x 3/4"hexbolts,
1/4"washers and1/4"flanged nuts. T IGHTEN. See
figure23.
•
TIGHTEN thefive1/4"flangednuts.
1/4"
WASHER
FIGURE
23
With the rope hanging down loosely', check if the
cover fits down freely around the rear of the cart tray.
If the cover needs to extend farther to the rear, loosen
bolts (a) in figure 24 to slide the support rod rearward.
If the rear of the cover does not rest down freely
around the rear of the cart tray, loosen bolts (b) in
figure 24 and tilt the front support tube rearward while
sliding the bottom of the braces rearward. Retighten
the bolts.
BOLT
B
FIGURE 24
BOLT
Allow the rope to hang loosely behind the rear of the
cart. Use the lanyard to tighten the rope until it firmly
secures the cart cover to the cart. See figure 25.
Ensure lanyard is locked to keep rope in place. See
figure 25.
FIGURE 25
15
Advertisement
