Advertisement
Slidethesecond lower support r od(bent e nds)
through thesleeve alongthebottom ofthecartcover.
Slidea looped endofthe ropeontotherodas it
enters eachgapinthesleeve. Thebendinthe rod
mustfaceinthedirection shown infigure15.
Place thetopsupport a ngleinside thecartcover.
Foldthebottom ofthecoveraround thetopsupport
angle. I nserttwoplastic plugsasshown infigure17
tosecure thecovertotheendsofthetopsupport
angle.
BOTTOM OF
CART COVER
3END
ROPE
LOWER
SUPPORT
BOTTOM SLEEVE
FIGURE 15
FIGURE 17
TOP SUPPORT ANGLE
Locate the plastic strips that are stitched to the
bottom of the cart cover. Cut seven slits in the cover
fabric that align with the holes in the plastic strips.
See figure 16.
Assemble the five 1/4" x 3/4" carriage bolts and
tinnerman nuts as shown, leaving the nuts loose
enough that the bolts can slide back and forth in the
slots. See figure 18.
CUT SLITS (7)
FIGURE 16
PLASTIC STRIPS
114"x 314"
CARRIAGE BOLT
-9
\
\
TINNERMAN NUT
FIGURE 18
13
Advertisement
