Advertisement
Electric Door Release
MODEL: DR-1 SERIES
Apartment House Communications & Lock
Control System Accessory
INSTALLATION INSTRUCTIONS
MOUNTING
The DR-1 door release mounts in place of the lock strike plate
on the left or right door jamb. It should be flush mounted and
mortised in place.
CONNECTIONS
Run 18 gauge 2-conductor wire from door release to amplifier
location and connect to door release terminals. Refer to the
amplifier system instruction sheets for connection details and
typical system wiring recommendation.
Note: Silent door release Direct-A-Com Series 3
For silent door release operation in "Direct-A-Com" series 3
installations, refer to Model SRA-1 silent release adapter and
Model IM-516 amplifier installation instructions.
Electric Door Release
MODEL: DR-1 SERIES
Apartment House Communications & Lock
Control System Accessory
INSTALLATION INSTRUCTIONS
MOUNTING
The DR-1 door release mounts in place of the lock strike plate
on the left or right door jamb. It should be flush mounted and
mortised in place.
CONNECTIONS
Run 18 gauge 2-conductor wire from door release to amplifier
location and connect to door release terminals. Refer to the
amplifier system instruction sheets for connection details and
typical system wiring recommendation.
Note: Silent door release Direct-A-Com Series 3
For silent door release operation in "Direct-A-Com" series 3
installations, refer to Model SRA-1 silent release adapter and
Model IM-516 amplifier installation instructions.
INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
DR-1 DIMENSIONS
INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
DR-1 DIMENSIONS
Advertisement
Table of Contents
Related Manuals for NuTone DR-1 SERIES
Summary of Contents for NuTone DR-1 SERIES
-
Page 1: Installation Instructions
INSTALLATION INSTRUCTIONS READ & SAVE THESE INSTRUCTIONS! Electric Door Release MODEL: DR-1 SERIES Apartment House Communications & Lock Control System Accessory INSTALLATION INSTRUCTIONS MOUNTING The DR-1 door release mounts in place of the lock strike plate on the left or right door jamb. It should be flush mounted and mortised in place. - Page 2 WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. During this two year period, NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service. THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES, FILTERS, DUCT, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR DUCTING.
Need help?
Do you have a question about the DR-1 SERIES and is the answer not in the manual?
Questions and answers