Table of Contents
Advertisement
i_:iliiiiii%i;,,i_,_ii_
f:i_,,ii_i:::::i!
!iiiiiii_ii:!_,i::i_,_ii::::_l_'_'!_!i!!i_,_:_i!::::_iii
'¸_
IMPORTANT:
Your dishwasher
is designed to use a liquid rinse aid. The use of rinse aids greatly improves drying by allowing water to
drain from the dishes after the final rinse. They also keep water from forming droplets that can dry as spots or streaks. Do not use a
solid or bar-type rinse aid.
4. Clean up any spilled rinse aid with a damp cloth.
Filling the dispenser
5. Place the knob back into the opening and turn to the "Lock"
The rinse aid dispenser holds 5 oz (150 mL) of rinse aid. Under
normal conditions, this will last for about 1 to 3 months.
1. Make sure the dishwasher door is fully open.
2. Turn the dispenser knob to "Open" and lift it out.
A
.............
USERINSEAiDFOR
BETTER DRYING
Lock
.... @
A. Dispenser knob
B. Indicator
C. Indicator window
3. Pour rinse aid into the opening until the indicator points to
"Full." Take care not to overfill. (When the rinse aid indicator
drops to the "Add" level, add more rinse aid.)
Full
Add
position.
Rinse aid setting
The amount of rinse aid released into the final rinse can be
adjusted. For most water conditions, the factory setting of 2 will
give good results. If you have hard water or notice rings or
calcium spots on your glasses or dishes, try a higher setting.
Lock
Open
To adjust the setting
1. Remove the dispenser knob.
2. Turn the arrow adjuster inside the dispenser to the desired
setting by either using your fingers or inserting a flat-blade
screwdriver into the center of the arrow and turning.
3. Replace the dispenser knob.
10
Advertisement
Table of Contents
