Cleaningthe Burnergrates Burnercaps Burner Heads Simmerplateand Griddle - Electrolux E30DF74GPS2 Use & Care Manual

30/36" dual fuel ranges
Hide thumbs Also See for E30DF74GPS2:
Table of Contents

Advertisement

General Care & Cleaning
CLEANING THE BURNER GRATES, BURNER CAPS,
BURNER HEADS, SIMMER PLATE AND GRIDDLE
I
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
The Burner Grates, Burner Caps, Burner Heads, simmer plate
and griddle should be routinely cleaned. Keeping the burner
ports clean will prevent improper ignition and an uneven
flame.
Surface
Burner
Grate
Surface
Burner
Ca
Surface
Burner
Refer to the following instructions:
To Remove and Replace the Surface
Burner Grate, Surface Burner Cap
and Surface Burner Head - Remove in the following order: (1st) Surface
Burner Grate, (2nd) Surface Burner Cap, (3rd) Surface Burner Head;
18000BTU Dual Flame Burners Only (See Figure).
Reverse the procedure above to replace the Surface Burner Cap, Surface
_Burner
Head and Surface Burner Grate. Do not remove any burner parts
Electrode
_L_/from
the cooktop
until the burner parts have completely
cooled
and are
_safe
to handle. Do not operate
the surface
burners
without
the Surface
Burner Caps, Surface Burner Heads and Surface
Burner Grates properly
in place.
To Clean the Burner Caps, Burner Heads, Burner Grates, Simmer
Plate and Griddle
- Use a soap-filled scouring pad or a mild abrasive cleaner to clean the surface burner
caps and surface burner heads. The Grates, Simmer Plates and Griddle are designed to
be Dishwasher safe for cleaning. The ports (or slots) around the burner heads must be
routinely cleaned. If residue still remains in these ports, use a small-gauge wire or needle
to clean the slots or holes being careful not to damage the electrode. For proper flow of
gas and ignition of the burner--DO
NOT ALLOW SPILLS, FOOD, CLEANING AGENTS
OR ANY OTHER MATERIAL TO ENTER THE GAS ORIF_CE HOLDER OPENING.
ALWAYS make sure that the surface burner cap, the surface burner head and the surface
burner grate are properly in place whenever a surface burner is in use.
Surface Burner
Grate (2 or 3)
Surface Burner
Caps (4 or 6)
Surface Burner
Heads
THECOOKTOPHS NOT REMOVABLE.Do not attemptto removeor lift the cooktop.
I

Advertisement

Table of Contents
loading

Table of Contents