Cleaning Surface; Cleaning The Burner Grates, Burner Caps, Burner Heads, Simmer Plate And Griddle - Electrolux ICON Professional E30GF74HPS Use And Care Manual

CLEANING THE BURNER GRATES, BURNER CAPS,
BURNER HEADS, SIMMER PLATE AND GRIDDLE
The Burner Grates, Burner Caps, Burner Heads, simmer plate and griddle
should be routinely cleaned. Keeping the burner ports clean will
prevent improper ignition and an uneven flame.
Refer to the following instructions:
To Remove and Replace the Surface Burner Grate,
Surface Burner Cap and Surface Burner Head - Remove
in the following order: (1st) Surface Burner Grate, (2nd)
Surface Burner Cap, (3rd) Surface Burner Head; 18000BTU
Dual Flame Burners Only (See Figure).
Reverse the procedure above to replace the Surface Burner Cap,
Surface Burner Head and Surface Burner Grate. Do not remove
any burner parts from the cooktop until the burner parts have
completely cooled and are safe to handle. Do not operate the
surface burners without the Surface Burner Caps, Surface Burner
Heads and Surface Burner Grates properly in place.
To Clean the Burner Caps, Burner Heads, Burner Grates, Simmer Plate and Griddle
- Use a soap-filled scouring pad or a mild abrasive cleaner to clean the surface burner
caps and surface burner heads. The Grates, Simmer Plates and Griddle are designed to
be Dishwasher safe for cleaning. The ports (or slots) around the burner heads must be
routinely cleaned. If residue still remains in these ports, use a small-gauge wire or needle
to clean the slots or holes being careful not to damage the electrode. For proper flow of
gas and ignition of the burner—DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS
OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING.
ALWAYS make sure that the surface burner cap, the surface burner head and the surface
burner grate are properly in place whenever a surface burner is in use.
Surface Burner
Grate
THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.
CA CA UTION UTION
CAUTION CA CA UTION UTION
!
- Use caution when replacing the burner head so the electrode is not damaged. A damaged
electrode may cause a delayed ignition or prevent the burner from igniting
- Any additions, changes or conversions required in order for this appliance to perform
satisfactorily must be made by a qualified service technician.
Care & Cleaning
Surface
Burner
Grate
Surface Burner
Caps
1st
2nd
Surface
Burner Cap
3rd
Surface
Burner Head
Electrode
Surface Burner
Heads
27