Startingthe Ovenself-Cleancycle - Electrolux E30DF74GPS3 Use & Care Manual

Care & Cieanin
STARTINGTHE OVENSELF-CLEANCYCLE
I m [] [] [] [] [] [] [] I [] I [] [] [] [] [] [] it [] [] []
If you are planning to use the oven directly after a self-clean cycle remember to allow time
for the oven to cool down and the oven door to unlock. This normally takes about one hour.
So to self-clean for 3 hours will actually take about 4 hours to complete.
WARNING
During the self-cleaning cycle,the outsideof the range can become very hot to the touch. DONOT
leave small children unattended near the appliance; they may be burned if they touch the hot oven
doorsurfaces.
CAUTION
DO NOTforce the oven door open.This candamagethe automatic door locking system. Use care
when openingthe oven door after the self-cleaning cycle. Stand to the side of the oven when opening
the door to allow hot air or steam to escape.The oven may still be VERYHOT.
To start a Self-Cleaning cycle:
1. Be sure oven is empty and the oven door is closed.
2. Turn the selector knob to Clean position.
3. The corresponding indicator light wilt flash.
4. Turn the Temperature Control Knob to Clean position.
5. The Lock indicator light will flash while transitioning from unlock to lock. It will stop
flashing when the door is locked.
NOTE
If the "Racks" indicatorlight is flashing whenthe clean mode is initiated,the oven racks and rack
glides with supports have not been removed, it will continue flashing, once the selector knob is set
back to the offpositionand the racks and rack glides with supports are removed from the oven.
6. As soon as the controls are set to clean, the motor driven oven door lock wilt begin to
close automatically. Once the door has been locked the indicator light will stop flashing
and remain on. Allow about 30 seconds for the oven door lock to close.