Usingthe Self-Cleanfeature - Electrolux E30DF74GPS3 Use & Care Manual

Care & Cleanin 25
USINGTHE SELF-CLEANFEATURE
[] [] i [] [] [] I [] [] [] [] [] [] [] []
Adhere to the FollowingCleaningPrecau-
tions:
• Allow the oven to cool before cleaning.
• Wear rubber gloves when cleaning any exterior parts of the
oven manually.
During the self-cleaning cycle, the outside of the range can
become very hot to the touch. DO NOT leave a small children
unattended near the range.
[] [] [] [] [] []
Do NOT Do Hand
Hand Clean
Clean Door Frame
Gasket
Before cleaning any part of the oven, be sure the oven is turned
off. Wait until the oven is cool.
Do Hand Clean Door Area
which out of the Door Gasket
The health of somebirds is extremely sensitiveto the fumes given off duringthe
self-clean cycleof anywall oven. Movebi rds to anotherwell ventilatedroom.
DO NOT use commercial oven cleaners or oven protective coatings in or around any part
of the self-cleaning oven. DO NOT clean the oven door gasket. The gasket on the oven
door is essential for a good seal. Care should be taken not to rub, damage or move the
gasket. DO NOT use any cleaning materials on the gasket. Doing so could damage it. DO
NOT use aluminum foil to line the oven bottom. This may affect cooking or foil could melt
and damage the oven surface.
A self-cleaning oven cleans itself with high temperatures (well above cooking tempera-
tures) which eliminate soil completely or reduce it to a fine powdered ash you can whisk
away with damp cloth.
Preparingthe Oven for Self-Cleaning
1= Remove any excess spillovers in the oven cavity before starting the self-cleaning
cycle. To clean, use hot soapy water and a cloth. Large spillovers can cause smoke or
a fire when subjected to high temperatures. DO NOT allow food spills with a high sugar
or acid content (such as tomatoes, sauerkraut, fruit juices or pie filling) to remain on the
surface as they may leave a dull spot even after cleaning.
2. Clean any soil from the oven frame and the door liner (see illustration). These areas
heat sufficiently during a self-clean to burn soil on. Clean with hot soapy water:
3. Remove all utensils and any foil. These items cannot withstand high cleaning tempera-
tures.
4. Oven racks and oven rack supports must be removed. If they are not removed the self-
cleaning cycle cannot start and the" Racks" Indicator Light will begin to flash indicating
that you must remove the racks and rack gliders with the supports before starting the
clean cycle. When the cycle has finished and the door can be opened, replace the oven
the oven rack supports and oven racks.