Table of Contents
Advertisement
Care & Cleanin
USINGTHE SELF-CLEANFEATURE
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
I
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
DO NOT
Hand
DO Hand
Clean Door
Clean
Gasket
Frame
DO Hand Clean Door Area
which out of the Door Gasket
Adhere to the FollowingCleaning
Precautions:
. Allow the oven to coot before cleaning.
• Wear rubber gloves when cleaning any exterior parts of
the oven manually.
During the self-cleaning cycle, the outside of the range
can become very hot to the touch. DO NOT leave a small
children unattended near the range.
Before cleaning any part of the oven, be sure the oven is
turned off. Wait until the oven is cool.
The health of somebirds is extremely sensitiveto the fumes given off during the
self-cleancycleof any wall oven.Movebirds to another well ventilatedroom.
DO NOT use commercial oven cleaners or oven protective coatings in or around any part
of the self-cleaning
oven. DO NOT clean the oven door gasket. The gasket on the oven
door is essential for a good seal. Care should be taken not to rub, damage or move the
gasket. DO NOT use any cleaning materials on the gasket. Doing so could damage it. DO
NOT use aluminum
foil to line the oven bottom. This may affect cooking or foil could melt
and damage the oven surface.
A self-cleaning
oven cleans itself with high temperatures
(welt above cooking
temperatures) which eliminate soil completely or reduce it to a fine powdered ash you can
whisk away with damp cloth,
Preparingthe Oven for Self-Cleaning
1. Remove any excess spiliovers in the oven cavity before starting the self-cleaning
cycle. To clean, use hot soapy water and a cloth. Large spillovers can cause smoke or
a fire when subjected to high temperatures.
DO NOT allow food spills with a high sugar
or acid content (such as tomatoes, sauerkraut, fruit juices or pie filling) to remain on the
surface as they may leave a dull spot even after cleaning.
2. Clean any soil from the oven frame and the door liner (see illustration). These areas
heat sufficiently during a self-clean to burn soil on. Clean with hot soapy water.
3. Remove all utensils and any foil. These items cannot withstand high cleaning
temperatures.
4. Oven racks and oven rack supports must be removed. If they are not removed the self-
cleaning cycle cannot start and the" Racks" Indicator Light will begin to flash indicating
that you must remove the racks and rack gliders with the supports before starting the
clean cycle. When the cycle has finished and the door can be opened, replace the oven
the oven rack supports and oven racks.
Advertisement
Table of Contents
