Operating Thesinglesurfaceradiant E Jements 10 Operating Thedualsurfaceradiant E Lement - Electrolux E36EC75HSS1 Use & Care Manual

Setting Surface Controls
Your cooktop is equipped with a dual radiant surface element
located at the right front position (See Fig. 1). Symbols around
the knob are used to indicate which coil of the dual radiant
element will heat. The _ symbol indicates that only the inner
coil will heat (Fig. 2). The ® symbol indicates that both inner
and outer coils will heat (Fig. 3). You may switch from either
coil setting at any time during cooking.
To Operate the Dual Surface
Element:
Fig. 1
1. Place correctly sized cookware on the dual surface
element.
2. Push in and turn the control knob counterclockwise
(See Figs. 2 & 3) for smaller cookware or clockwise
(See Figs. 3 & 4) for larger cookware to the
desired setting using the ESEC digital display
window for the desired setting.
3. Turn the knob to adjust the setting as needed.
Start most cooking operations on a higher setting
and then turn to a lower setting to finish cooking.
Each surface element provides a constant amount
of heat at each setting. A glowing red surface
heating area extending beyond the bottom edge
of the cookware indicates the cookware is too
small for the surface heating area.
4. When cooking has completed, turn the surface
control knob to OFF before removing the cookware.
Also, the HE message will appear in the display
Fig. 2
Fig. 4
Fig. 3
Fig. 5
after turning the control knob to OFF if the cooktop is still hot and remain on until the heating
surface area has cooled sufficiently.
_;_' _ 'i!_ "_
SeetheRecommended SettingforSurfaceElements chart,onpage8,tomakethecorrectsetting.
Radiant surfaceelements may appearto becooledafterthey have beenturned OFF.HE(Hot Element)
messagewill turn ONand will continueto glowuntil the glasscooktophas cooleddownto a moderate
level. The glass surfacemay still behot and burnsmay occurifthe glasssurfaceistouched before the
indicator Lighthas turned OFF.