Download Print this page
Electrolux ICON Designer E36EC65ESS Installation Instructions
Electrolux ICON Designer E36EC65ESS Installation Instructions

Electrolux ICON Designer E36EC65ESS Installation Instructions

Electrolux icon designer e36ec65ess: installation guide
Hide thumbs Also See for ICON Designer E36EC65ESS:

Advertisement

ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in
WARNING
the vicinity of this or any other appliance.
Cooktop Dimensions
30" Min. *
(76.2 cm)
A
E
Cooktop Cutout
Dimensions
G
MODEL
30" Ceramic Model
36" Ceramic Model
MODEL
30" Ceramic Model
36" Ceramic Model
All dimensions are in inches (cm).
* Allow 2" (5 cm) space below cooktop to clear the electric cable and allow for installation of the junction box on the
wall at the back of the cooktop.
Printed in United States
B
C
D
H
PRODUCT DIMENSIONS
A. LENGTH
B. WIDTH
30¾ (78.1)
21½ (54.6)
36¾ (93.3)
21½ (54.6)
CUT OUT DIMENSIONS
F. LENGTH
MINIMUM
MAXIMUM
29
5
/
(75.2)
30 (76.2)
8
35
5
/
(90.5)
36 (91.4)
8
IMPORTANT INSTALLATION INFORMATION
• All electric cooktops run off a single phase, three-wire
or four-wire cable, 240/208 volt, 60 hertz, AC only
electrical supply with ground.
• Minimum distance between cooktop and overhead
cabinetry is 30" (76.2 cm).
F
* 30" (76.2 cm) min. for unprotected cabinet
24" (61 cm) min. for protected surface
Figure 1
C. DEPTH
4 (10.2)
4 (10.2)
G. WIDTH
MINIMUM
20¼ (51.4)
20¼ (51.4)
1
D. BOX LENGTH
E. BOX WIDTH
5
/
28
(72.7)
19¼ (48.9)
8
34
5
/
(87.9)
19¼ (48.9)
8
H. DEPTH BELOW
MAXIMUM
COOKTOP*
20½ (52.1)
6 (15.2)
20½ (52.1)
6 (15.2)
P/N 318201428 (0509) Rev. A
English – pages 1-5
Español – pages 6-10
Français - pages 11-15
Notes - 16

Advertisement

loading

Summary of Contents for Electrolux ICON Designer E36EC65ESS

  • Page 1 ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in WARNING the vicinity of this or any other appliance.
  • Page 2 If cabinet storage is provided, risk can be reduced by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of the cabinets. Figure 2 – COUNTERTOP CUTOUT OPENING Min.
  • Page 3: Important Safety Instructions

    ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS Important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing the cooktop. 2. Remove all packing material before connecting the electrical supply to the cooktop. 3. Observe all governing codes and ordinances. 4.
  • Page 4: Electrical Connection

    ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS Electrical Connection Connect the flexible armored cable that extends from the surface unit to the junction box using a suitable strain relief at the point the armored cable enters the junction box. Then make the electrical connection as follows. Electrical ground is required on this appliance.
  • Page 5: Cooktop Installation

    ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS Cooktop Installation 1. Visually inspect the cooktop for damage. Also make sure all cooktop screws are tight (see Figure 6). Screws Figure 6 2. Install the retainer brackets. See Figure 7 The retainer brackets MUST be installed, to meet local codes or, in their absence, with the National Electrical Code ANSI/NFPA No.