Door Reversal - Electrolux ERC3711WS Instruction Booklet

The appliance must be placed at a location whose
ambient temperature corresponds to the climate
classification*, for which the appliance is designed.
* See on the rating plate on the inside of the
appliance.
The following table shows which ambient
temperature is correct for each climate classification.
Climate
for an ambient temperature of
classification
SN
N
ST
T

Door Reversal

1. Close the appliance and disconnect the appliance
from the electricity socket.
2. Remove the ventilation grille. There is a part on
the grille that can be removed. Remove and
reposition it on the opposite side.
3. Support the appliance on a wooden block when it
is laid down. This will make it easier to grip under
the appliance when returning to an upright position.
4. On the upper part of the appliance. Remove the
hinge pin and replace on the other side.
On the lower part of the appliance. Unscrew the
hinge. Move the hinge pin and plastic cover. Secure
the hinge on the other side.
Remove any play in the door by adjusting the height
of the lower hinge with the supplied spanner. Secure
with the lock-nut.
5. Raise the appliance and replace the ventilation
grille.
6. Move the handle.
Unscrew the handle and secure it to the other side.
Press the supplied plastic plugs into the holes to
which the handle was previously fitted.
7. Put the appliance in position. Check that the
appliance is level. See the section "Positioning the
appliance".
+10°C to +32°C
+16°C to +32°C
+18°C to +38°C
+18°C to +43°C
Check that the drain hose at the rear of the appliance
discharges into the drip tray.
If the appliance is placed in a corner and the side
with the hinges facing the wall, the distance between
the wall and the appliance must be at least 230 mm
to allow the door to open enough so that the shelves
can be removed.
The power plug must be accessible after installation
of the appliance.
1
2
3
4
6
11
Electrolux 818 35 40-00/7